Cd Audio; Analog Out; Audio Modes; Device Configuration Jumper - Toshiba SR-C8002 Product Specification

8.CD Audio (Test condition: Ordinary temperature)
8.1. Analog Out --- in case of the attenuator is set at 0 dB by the command ---
(1) Output Level
(2) Type
(3) Load Impedance
(4) Frequency Response
(5) Distortion
(6) Signal to Noise Ratio

8.2. Audio Modes

(1) 16 Modes including 'Stereo', 'Lch Mono', 'Rch Mono' and 'Mute' are selectable by command.
Default mode is 'Stereo'.
(2) 16 Steps of attenuation level for the Audio Output is selectable by command.
Default level is 0 dB.

9. Device Configuration Jumper

9.1. Master Mode Setting

Short-circuit the PIN 47 and PIN 48 of I/O connectors.

9.2.Slave Mode Setting

Open the PIN 47 of I/O connectors.
(Optional)
9.1. Master Mode Setting
Open the PIN 47 of I/O connectors.
9.2. Slave Mode Setting
Short-circuit the PIN 47 and PIN 48 of I/O connectors.
0.8 V (rms)+/-1 dB
Unbalanced
47 kOHM min
20 Hz to 20 kHz+/-3.0 dB. (at 47 kOHM Load)
0.04 % Max. (at 1 kHz w/20 kHz LPF)
80dB Typ (IEC179 A-Weighted)
19/24
SR-C8002 Rev.1.0