Toshiba 120/150 Operator's Manual page 61

6
Copying files for MFP driver installation.
1. After confirming the message in the "Welcome" window, click the "Next" button.
2. A dialog box appears asking you to verify that the interface cable is not connected to the MFP. Make
sure that the interface cable is not connected and click the "Next" button.
3. Click the "Next" button in the dialog box showing the files
to be copied for installation of the MFP driver.
• The setup program will start to copy the files.
• In Windows 2000, if the following screen appears while
the files are being copied (the message may appear more
than once), click "Yes" in Windows 2000.
4. The following screen appears when all of the files for the
USB interface connection have been copied. If you are
not using a parallel interface cable for connection to the
MFP, please click the "No" button.
5. When the "The MFP driver installation is complete." dialog box appears, click the "OK" button.
• The Button Manager installer will start.
7 Begin installation of the Button Manager (This step will start if it was selected in step 4).
1. After confirming the message in the "Welcome" window, click the "Next" button.
2. Read the message in the "Please read the following information." window, and then click the "Next"
button.
3. When a message appears that lets you specify the location for the software to be installed, click the
"Next" button.
4. If the program displays "Do you want to add Button Manager to Startup program?", check "Yes" and
click the "OK" button.
• The setup program will start to copy the files.
5. Click the "Finish" button when the message to inform you of the completion of the installation
appears.
• The Desktop Document Manager installer will start.
7-10
INSTALL THE SOFTWARE