Precor Queenax UFO Assembly

Page 1 of 3

Queenax UFO assembly

UFO
The UFO is a suspended platform that is designed to enhance motor
control, balance, rhythm, body awareness, mental engagement and
strength. The UFO's four anchor points accommodate suspended
bodyweight training in 360 degrees. Users can sit, stand or kneel on the
UFO or position just the arms and legs on it, allowing for a variety of
exercise possibilities.

UFO location

The UFO is best mounted in the open space centered between two
training bars. Depending on configuration and space available, the
UFO can also be mounted centered on a single training bar.

UFO bracket assembly

The UFO hangs from four mounting brackets that are attached
to the horizontal beam (see Exploded view below).
1. Mount each bracket loosely to the beam. Space the brackets
30 cm apart (2 open holes in between brackets). If space is
constrained the brackets can be mounted 40 cm or 50 cm (3
or 4 open holes in between brackets) apart.
2. Insert the Cross Bars.
3. Attach the Strap Guards.
4. Fully tighten all hardware.
5. Tighten the four set screws that secure the Cross Bars.
6. Inflate and setup UFO (see UFO setup steps below).
Contact Precor customer support at support@precor.com or 800.786.8404 with any questions.
©2017 Precor Incorporated, Unauthorized reproduction and distribution prohibited by law.
QUEENAX ASSEMBLY BULLETIN
AB.QX.20170630
Page 1 of 3