Download Print this page

Videofield SE650 Installation Instructions

Exterior siren/strobe

Advertisement

Quick Links

Product Summary
The Exterior Siren/Strobe Model SE650/SE550/SE750 is a wireless
siren designed for use in RSI VIDEO TECHNOLOGIES™ security sys-
tems. The siren includes the following features:
>
Totally wireless, battery operated
>
Weather-resistant enclosure
>
Dual tamper function provides detection for both wall
and cover tamper.
>
Transmits check-in/status signal every 8 minutes
Programming/RF Testing
The following provides summarized steps for device
programming and testing. For complete details, refer
to the control panel installation manual.
1
Remove four cover
screws, separate cover
from siren and install
batteries.
2
Put control panel
into programming/
configuration mode.
3
Using a programmed
alphanumeric keypad,
proceed through menus
until the display shows
ADD A NEW DEVICE.
4
Press Yes. The display
shows PRESS PROGRAM
BUTTON OF DEVICE.
5
Press and release
program button on siren
using a paper clip end.
The siren LED flashes.
Wait for keypad display
to show SIREN (1 - 24)
RECORDED.
Exterior Siren/Strobe Model
Made by RSI VIDEO TECHNOLOGIES
Installation Guidelines
For easier installation, programming and RF testing
should be done to check for good communication between
the control panel and all system devices before mounting
system devices. Install the siren and other system devices
in the following order:
>
>
6
7
8
9
Screws
10
Program Button
I N S T A L L A T I O N I N S T R U C T I O N S
Programming/RF Testing—program siren and
all other devices into the control panel and test
RF communication from each intended device
location to the control panel.
Mounting—mount siren at the tested location.
Press Yes. The display shows RADIO RANGE TEST?
Press Yes again. The siren LED starts flashing and
keypad display shows TEST IN PROGRESS.
Take siren to its intended mounting location and
make sure LED flashes continuously, indicating good
communication with control panel.
Press Yes to end radio range test, then press Esc/No.
The display shows ADD A NEW DEVICES?
Repeat steps 4 - 8 for remaining sirens.
When finished, exit from configuration mode.
www.videofied.com
SE650/SE550/SE750
1012-c February 2008

Advertisement

loading
Need help?

Need help?

Do you have a question about the SE650 and is the answer not in the manual?

Questions and answers

Summary of Contents for Videofield SE650

  • Page 1 1012-c February 2008 Product Summary Installation Guidelines The Exterior Siren/Strobe Model SE650/SE550/SE750 is a wireless For easier installation, programming and RF testing siren designed for use in RSI VIDEO TECHNOLOGIES™ security sys- should be done to check for good communication between tems.
  • Page 2 Exterior Siren/Strobe Model SE650/SE550/SE750 I N S T A L L A T I O N I N S T R U C T I O N S Mounting > Use proper tools and hardware for mounting the unit. Remove batteries.

This manual is also suitable for:

Se550Se750