Advertisement
Quick Links
Instructions of shipment, unpacking and installation.
General scheme of the awning
A ‒ Brackets
B ‒ Square tube
C ‒ clamping screws
D ‒ Roller tube with fabric
E ‒ Front profil
F ‒ lower brackets
G ‒ Side vertical profiles
H ‒ Transverse profile
J ‒ uchwyty narożne
O ‒ Trolley
N ‒ Mounting screw
Steering:
[ ] Manual,
[ ] E-drive,
[ ] Motor drive with NHK
Data of electric drive:
Power ..................... W, Voltage 230V;
Frequency 50Hz;
Data from the additional drive/lighting:
Power ..................... W, Voltage 230V;
Frequency 50Hz;
YOC: .................................................
Serial Number: ..................................
CAUTION!
These instructions must be read and understood before installation, adjustment,
service or maintenance.
Operations and Maintenance,
Pergola awning EVO
.......................................
EN 13561
External blinds
Class of wind resistance:
.......................................
strona: 1 / 14
Advertisement
Summary of Contents for sunair Pergola EVO
- Page 1 strona: 1 / 14 CAUTION! These instructions must be read and understood before installation, adjustment, service or maintenance. Operations and Maintenance, Instructions of shipment, unpacking and installation. Pergola awning EVO General scheme of the awning A ‒ Brackets B ‒ Square tube C ‒...
- Page 2 strona: 2 / 14 Content 1. Introduction 2. Instructions for use and maintenance 3. Transportation, unpacking and installation instructions Introduction These installation instructions are an integral part of the terrace awning and was written for the professionals of the installation company and for the end users. An additional instruction for the electric products will be attached to this manual and should be treated as an integral part of this instruction.
- Page 3 strona: 3 / 14 Use and Maintenance instruction 2.1. General CAUTION! For the reasons of safety, installation, maintenance and use of awnings, please follow the following guidelines. The installation of the awning should be done by an authorized dealer. Modifying the construction of the awning are not allowed. It is not be allowed to under awning be during maintenance or installation work.
- Page 4 strona: 4 / 14 Switch should be placed in such a place where we can see the awning position in any movement. Switch should be located away from moving parts. Switch should be installed at a height according to the regulation for the disabled persons (generally less than 1,30 m).
- Page 5 strona: 5 / 14 2.5. Disassembly and disposal Disassembly of the awning must be performed by qualified personnel. Awning contains no hazardous components. Turn to recycling company to reduce the negative influence of waste over the natural environment. 2.6. Important notes and warnings CAUTION! Roll up the awning in bad weather such as frost, snow, rain and hail.
- Page 6 strona: 6 / 14 Note Fabric is narrower (from 10 to 15 cm) than the total width of the awnings frame; depending on the type of drive, from 10 cm to 15 cm. Do not dispose of electrical components in the trash. It must be deliver to the point of disposal of electrical equipment.
- Page 7 Instructions of shipment, unpacking and installation 3.1. Delivery 1x Pergola awning Type: Pergola EVO, Brackets in an amount of 2 or 3 wall or ceiling brackets + 2 lower guide rails, 1x Service Manual, 1x Operating and Maintenance Instructions, Warranty,...
-
Page 8: Check Delivery
strona: 8 / 14 3.5. Qualifications of the installation team Observe safety rules. Ability to use of ladders and scaffolds. Ensure transport and storage of the awning. Experience in the use of tools and equipment. Appropriate certificate of approval and use for fixing materials in construction. Installation training at Dragon company (recommended). - Page 9 strona: 9 / 14 3.8.2. Marking and fixing of the mounting brackets CAUTION! In order to avoid the risks associated with moving parts of the awnings, device must be installed at such a height that the lowest moving part will be at least 220 cm from the ground.
- Page 10 strona: 10 / 14 3.8.4. Marking and fixing the pergola awning frame. Note The main task of the pergola awning EVO is the protection from sunlight. There is also the possibility of extra protection from the rain. The effectiveness of the removal of water depends on the awning fabric, the width of the awning, and its angle of inclination.
- Page 11 strona: 11 / 14 3.8.5. Screw the front profile to trolley; check operation of awnings CAUTION! For correct operation of the awning, it is necessary that the side profiles are perfectly parallel to each other, and the connection between the front profile and trolley are sliding on one side as described below.
- Page 12 strona: 12 / 14 In an unroll position, the front profile (E) and the intermediate support (EX) are adjacent to each other. When roll up intermediate support slide down under gravity into the middle of the depth, where is lock (Z) (Fig No.8) which stops the awning.
- Page 13 strona: 13 / 14 3.8.6. Laying electrical cables (only for motor drive) CAUTION! The electrical connection must be performed by a licensed professional. Connect the electrical wires according to the circuit diagram. The awning may only be connected if the specifications on the type plate agrees with your power source. When laying the motor cable, make sure that no kinks or any sharp edges they can damage the cable.
- Page 14 strona: 14 / 14 3.9. Repair the awning Repairs should be carried out only by a specialist. Only spare parts from DRAGON can be used. 3.9.1. Replacement a drive In order to make a repair to a defective drive, the awning must be using a belt secured. All the necessary work can be made only by a specialist.
Need help?
Do you have a question about the Pergola EVO and is the answer not in the manual?
Questions and answers