Do you have a question about the ROLDECK CONTROL RD 2013 and is the answer not in the manual?
Questions and answers
Summary of Contents for Starline ROLDECK CONTROL RD 2013
Page 1
All rights reserved. Nothing from this publication may be copied, stored in an automated database or made public in any shape or form whether electronically, mechanically, through photocopying, recording or in any other way without prior written permission from Starline Pools & Equipment. Copyright Starline Pools & Equipment The Netherlands.
Page 2
CONTENTS / INHOUDSOPGAVE INTRODUCTION TO THE STARLINE ROLDECK CONTROL RD 2013 INTRODUCTIE VAN DE STARLINE ROLDECKBESTURING RD 2013 INSTALLATION INSTRUCTIONS / SAFETY INSTRUCTIONS INSTALLATIE VOORSCHRIFTEN / VEILIGHEIDS INSTRUKTIES OVERVIEW CONTROL / OVERZICHT BESTURING OPERATING THE KEY SWITCH / BEDIENING VAN DE SLEUTELSCHAKELAAR OPENING &...
Page 3
Roldeck. During the opening or closing of the Roldeck, the control, in combination with the Starline pool control, offers the possibility of switching off the filter pump first and activating the Roldeck after a delay of 30 seconds.
Page 4
Roldeck ernstig verstoren. De besturing biedt de mogelijkheid om in combinatie met de Starline Poolcontrol bij het openen of sluiten van het Roldeck eerst de filterpomp uit te schakelen en na een vertraging van 30 seconden het Roldeck te activeren.
Page 5
The connection diagram and the prevailing safety regulations must be taken into account. • It is preferable for the 230 Volt connection of the RD 2013 to be connected over the Starline Pool control. If this is not possible, the RD 2013 can be connected directly to the 230V mains voltage which has an earth leakage circuit breaker with a IFN value of ≤...
Page 6
Het aansluitschema en de op dat moment geldende veiligheidsvoorschriften dienen in acht te • worden genomen. De 230 Volt aansluiting van de RD 2013 wordt bij voorkeur over de Starline Poolcontrol • aangesloten. Indien dit niet mogelijk is wordt de RD 2013 rechtstreeks op de netspanning 230V.
OPERATING THE KEY SWITCH / BEDIENING VAN DE SLEUTELSCHAKELAAR PLEASE NOTE: LET OP: To operate the Roldeck the key switch must be in Om het Roldeck te kunnen bedienen moet de position 1. sleutelschakelaar in stand 1 staan. If the key switch is in position 0 it works as Als de sleutelschakelaar in stand 0 staat werkt emergency stop and the Roldeck is not operable.
OPENING & CLOSING OF THE CONTROL HOUSING OPENEN & SLUITEN VAN DE BESTURINGSKAST OPENING OF THE CONTROL HOUSING OPENEN VAN DE BESTURINGSKAST PLEASE NOTE: LET OP: Before the housing is opened the equipment must be switched Vóór het openen van de behuizing dient het apparaat off*.
OVERVIEW ROLDECK CONTROL / OVERZICHT BESTURINGSKAST 13 14 15 16 9 10 11 12 Closing Speed Closing Speed J401 13 14 15 16 9 10 11 12 N L1 Ls J200 bl. br. sw. Power Switch J200 R E L503 RE L502 RE L501 R EL500...
Page 11
LED display External motor In-roller motor Externe motor Buismotor Display Rotation direction (open / close) / Draairichting ( sluiten / openen) Closing Roldeck: edge flashes when running motor. Roldeck sluiten: randje knippert bij lopen motor Display or / of Opening Roldeck: edge flashes when running motor. Roldeck openen: randje knippert bij lopen motor Display Endposition Roldeck / Eindstand Roldeck...
OVERVIEW LED’S AND MALFUNCTION MESSAGES OVERZICHT LED’S EN STORINGSMELDINGEN 13 14 15 16 9 10 11 12 J200 Below describes the functions of the LED’s Hieronder worden de functies van de LED’s weergegeven Description Omschrijving Signal open Signaal open Keyswitch Sleutelschakelaar Signaal Signal close Signaal Signaal dicht...
Page 13
LED error & display error / LED storing & foutmelding op display Description Omschrijving Error LED13 Motor not receiving 24V. voltage. Motor krijgt geen 24V. Wrongly connected. Verkeerd aangesloten. • • Power cable is broken. Voedingskabel onderbroken • • • Drive motor not running/blocked.
ELECTRICAL CONNECTIONS / ELECTRISCH AANSLUITEN OVERVIEW OF CABLING IN COMBINATION WITH GLAND NUTS / OVERZICHT VAN BEKABELING IN COMBINATIE MET WARTELS X200 J104 J103 J102 X300 X301 X303 X302 J402 J201 J400 3,15A/T B - P 1a 2a 3a 4a A B X Y 13 12 11 23 21 43 41...
Page 15
It is preferable for the Roldeck control to be connected directly De Roldeckbesturing wordt bij voorkeur direct aangesloten op to the Starline Pool control, to the connections “230V OUT” de Starline Poolcontrol, op de aansluitingen “230 V OUT” (zie (see Pool control instruction manual)
Need help?
Do you have a question about the ROLDECK CONTROL RD 2013 and is the answer not in the manual?
Questions and answers