Advertisement
Quick Links
50in Recycler Kit
for TITAN Zero-Turn-Radius Riding Mower
Model No. 117-5312
Installation
Loose Parts
Use the chart below to verify that all parts have been shipped.
Procedure
1
2
3
4
5
1
Preparing the Mower
No Parts Required
Procedure
1. Stop the engine and remove the ignition key.
2. Remove the mower as described in your Operator's
Manual.
3. Turn the mower upside down.
4. Remove the mower blades as described in your
Operator's Manual.
© 2009—The Toro® Company
8111 Lyndale Avenue South
Bloomington, MN 55420
Description
No parts required
Left baffle
Right baffle
Knob
Curved washer
Kicker plate
Phillips head screw (#8 x 5/8 inch)
Recycling decal
Recycling mower blade
Register at www.Toro.com.
Qty.
–
Prepare the mower.
1
1
Install the upper baffle.
4
4
3
Install the kicker plates.
6
1
Instal the decal.
3
Install the blades and mower
2
Installing the Baffles
Parts needed for this procedure:
1
Left baffle
1
Right baffle
4
Knob
4
Curved washer
Procedure
1. Locate the four holes in the mower where the baffle
mounting studs will mount (Figure 1) and remove
any fasteners from them.
2. Install the left baffle into the deck securing the studs
on the baffle from the top of the mower using 2
knobs and curved washers (cupped side facing the
mower) as shown in Figure 1 and Figure 2.
Form No. 3362-196 Rev A
Installation Instructions
Use
Original Instructions (EN)
Printed in the USA.
All Rights Reserved
Advertisement
Related Manuals for Toro 117-5312
Summary of Contents for Toro 117-5312
-
Page 1: Loose Parts
Form No. 3362-196 Rev A 50in Recycler Kit for TITAN Zero-Turn-Radius Riding Mower Model No. 117-5312 Installation Instructions Installation Loose Parts Use the chart below to verify that all parts have been shipped. Procedure Description Qty. – No parts required Prepare the mower. - Page 2 Figure 2 1. Knob 3. Baffle stud coming through the mower 2. Curved washer 3. Slide the right baffle through the discharge opening and secure it using 2 knobs and curved washers (cupped side facing the mower) as shown in Figure 1 and Figure 2.
- Page 3 Installing the Kicker Plates Installing the Decal Parts needed for this procedure: Parts needed for this procedure: Kicker plate Recycling decal Phillips head screw (#8 x 5/8 inch) Procedure Procedure Install the decal on left side of mower (Figure 4). 1.
-
Page 4: Operating Tips
Operating Tips Operation Selecting the Proper Height-of-Cut Converting to Side-discharge Setting to Suit the Conditions Operation Remove approximately one inch or no more that 1/3 of the grass blade when cutting. In exceptionally lush and dense grass you may have to raise the height-of-cut setting another notch or convert to side discharge or Without the grass deflector, discharge cover, bagging operations.