Honey Extractor Diagram; Characteristics For Honey Extractors - LYSON MINIMA Series Manual

the engine and the controller against damping (it can
be covered with a water-proof material)
4. After washing, rinse and dry the honey extractor
thoroughly.
5. Frame arrangement:
●
Honey extractor must be property selected for a
given frame type.
●
Frames must be placed inside the basket in
line with the pat tern (photo 1)
fot.1 Proper frame arrangement inside the radial honey
extractor
Erroneous frame arrangement may bring about the
damages which are not subject to guarantee terms!
6. Prior to the honey extractor activation, one must:
●
make sure that the frames have been property
arranged inside the basket in order to eliminate
the risk of damage.
●
next, connect the honey extractor to the
feeder/battery (12V) and activate the device in
line with the manual
7.
The first phase of extraction shall be performed slowly
in order to prevent the honeycombs from breaking out.
Special attention must be paid to the so called "young
frames".
8.
The spinning basket should not be blocked by the
honey accumulating inside the drum. If that is the case,
the honey extractor must be stopped in order to avoid
any damage. Once the honey has drained to the
containers, spinning may be restarted
9.
A container intended for the honey shall be placed
under the drain valve.
10.
While spinning the drain valve should be opened in
order for the honey to flow freely
NOTE!
.
.
.

Honey extractor diagram

3.
Legend:
1. Honey extractor drum
2. Honey extractor leg
3. Drain valve
4. Honey extractor engine
5. Honey extractor beam
6. Honey extractor lid
7. Fixing controlling
4. Characteristics for honey extractor
The controller in a plastic casing is fixed to the honey
extractor beam. The honey extractors are sent with
dismantled controller, placed inside the basket, in order
to prevent against damages during transit.
4.1. Radial honey extractor with 12 V power supply
Honey extractors are intended for stationed and movable
apiaries. Power supply from a battery (12V) allows to
extract the honey without the access to the mains
(230V).
Honey extractor may be operated in manual and
automatic mode.