Page 2
DRUG-FREE PAIN RELIEF TISSUE REGENERATION WHOLE BODY CONDITIONING Congratulations on your choice of coMra Palm – the personal device for your daily health! Over the following pages you will find everything you need to start using your new device. And no...
Page 3
DEVICE LAYOUT AND TECHNICAL SPECIFICATIONS BOTTOM 63 mm Start button/center point Frequency button REAR Time button Frequency and Time display area Infrared laser Colour LEDs Magnets (internal) Battery on/off switch Battery charging LED Micro USB charging port LIGHT EMITTING DIODES Power: 5V --- 500 mA High Power USB port compatible Wavelength: Red 650 nm, Indigo Violet 420 nm, Battery: 450 mAh (lithium ion battery)
GETTING STARTED Plug the micro end of the USB cable into the micro USB port at the rear of your coMra Palm, and the other end into any powered USB port (computer, laptop, powerbank, etc.), or a mains electrical socket (using a suitable adaptor).
Page 5
An app, listing over 200 treatable conditions, can be downloaded for iOS and Android here: www.comra-palm.com/comra-app Alternatively, you can get a printable PDF here: www.comra-palm.com/comra-userguide Please read all the IMPORTANT information in the coMra user guide, before using your coMra Palm for the first time.
Page 6
C O H E R E N T M U LT I - R A D I A N C E S Enter dis-ease, condition or keyword FOREWORD BEFORE YOU START OPERATING INSTRUCTIONS To power-up your coMra Palm, slide the on/off TREATMENTS switch to green.
Page 7
5-4-3 Start 2 mins 1 min mins shown in the coMra user guide. TREATMENT POINT mins Top of sternum S TA R T / S T O P F R E Q U E N C Y...
Page 8
Variable (V) 10 mins Place your coMra Palm onto the treatment 1K (1000 Hz) 5 mins 50 Hz 2 mins point, using the raised bump on the surface of 5 Hz 1 min the Start button as the centre point.
Page 9
If you need to pause the program for any reason, press the start button once. The start button will flash on/off to indicate the program has paused. To continue on from pause, press the start button once again. When the selected time comes to an end, two beeps will sound indicating the end of the program.
Page 10
Repeat the process for all the points on the treatment plan. When you have completed your treatment and finished using your coMra Palm, slide the on/ off switch to red and power-down the device to preserve battery life.
Page 11
FREQUENCY AND TIME DISPLAY There are four indicating triangles for the frequency setting (hertz) and four indicating triangles for the time setting (minutes). Once a program has started, the in-built timer will count-down and display the remaining minutes left for the program. When finished, 5-4-3 Start 2 mins...
USB cable into the micro USB port at the rear of your coMra Palm, and the other end into any powered USB port, or a mains electrical socket (using a suitable adaptor).
Page 13
When the battery is fully charged the red LED indicator will switch off. A full battery charge takes approximately 1 hour. Your coMra Palm can be used while charging. A full battery charge on your coMra Palm should allow you approximately 30 mins of daily treatment, for up to 10 days.
Page 14
18 months. This guarantee does not cover damage or defects caused by misuse or by failure to comply with the product’s user guide. REGISTER YOUR COMRA PALM TO ACTIVATE YOUR 18 MONTH WARRANTY www.comra-palm.com/register...
Need help?
Do you have a question about the Palm and is the answer not in the manual?
Questions and answers