Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Texecom Odyssey X
Summary of Contents for Texecom Odyssey X
- Page 1 Installation Manual Odyssey X Series INS627-2...
- Page 2 Introduction Odyssey X is a new range of modular external warning devices available in standard or backlit variants. The modular design allows for a choice of front covers to be installed on the common backplate. Please see the specification table for full details of each model. Features include:- •...
- Page 3 Odyssey X Installation Manual Accessing the Unit Odyssey X1 Shown, all models are the same. Undo the screw ( no need to remove it completely) and The Lid has two parked positions depress the tab to open the lid Screw Undo the screw and press the tab to access Wiring &...
- Page 4 Odyssey X Installation Manual Inserting the Odyssey X1 graphic (available separately, see page 2) Removing the light diffuser Gently flex the two sides of the lid outwards so that the tabs release from the lid. Lift the light diffuser upwards to release.
- Page 5 Odyssey X Installation Manual Inserting the Odyssey X3 graphic (available separately, see page 2) Removing the light diffuser Gently flex the two sides of the lid outwards to release the light diffuser at point A. Push the lens tabs inwards to disengage the light diffuser.
- Page 6 Odyssey X Installation Manual Odyssey X-W (Premier Elite V2.11.X or later) Battery Insertion & Learning procedure When installing a wireless sounder, the batteries should be installed and the device learned to the panel BEFORE it is mounted in the chosen location.
- Page 7 The Odyssey X-W are learned to a Zone on the control panel in the same way that Ricochet enabled detection devices are. The Zone type and Ricochet Device Mode is automatically assigned based on the type of device being learned. In the case of the sounder the Zone Type is set to "Custom"...
- Page 8 Odyssey X Installation Manual Mounting the Unit (all models) Select a suitable position to mount the unit, which satisfies the following criteria: • Highly prominent for maximum deterrence • Additional shelter (e.g. under the eaves) is an advantage • High enough to be out of normal reach to deter tampering •...
- Page 9 Internal Lid Tamper The Odyssey X is fitted with an internal lid tamper to prevent access to the electronics and wiring of the unit. The screw located on the inside of the internal hinged lid should be adjusted so that the tamper switch closes correctly when the lid is screwed into place.
- Page 10 Odyssey X Installation Manual For safety reasons, each Texecom sounder and strobe unit incorporates a unique patented engineer Hold-Off mode. This mode prevents the unit from self-activating during installation and maintenance, thereby allowing only bona fide engineers access to the unit without any loss of tamper protection.
- Page 11 Odyssey X Installation Manual Backlight Wiring Options The backlight is wired for constant use from the factory; It is also possible to wire the backlight to the control panels outputs for different operation; for example, • the Backlight could be wired to activate with the strobe, •...
- Page 12 Odyssey X Installation Manual Please note, it cannot be guaranteed that the battery is fully charged on installation. When commissioning, the unit may require to be powered from the control panel for a period of time before the battery is sufficiently charged for self-activation.
-
Page 13: Technical Specification
Odyssey X Installation Manual The unit incorporates software which disables the strobe whilst the tamper switch remains open. This is a safety feature and cannot be disabled. The piezo drive produces high voltages when the siren is sounding. While not directly hazardous, these voltages will cause discomfort and should be avoided, particularly when using tools or a ladder. - Page 14 (excludes batteries) against defects in material or workmanship (details on request). Because the Odyssey X are not complete alarm systems but only a part thereof, Texecom cannot accept responsibility or liability for any damages whatsoever based on a claim that a unit failed to function correctly.
- Page 15 Odyssey X Installation Manual Notes: INS627-2...
-
Page 16: Technical Support
Texecom Limited, Bradwood Court, St. Crispin Way, Haslingden, Lancashire BB4 4PW, England. Technical Support: UK Customers Tel: 08456 300 600 (Calls charged at 3.36 pence per minute from a BT landline. Calls from other networks may vary.) International Customers Tel: +44 1706 233875 Email: techsupport@texe.com...
Need help?
Do you have a question about the Odyssey X and is the answer not in the manual?
Questions and answers