Sunmaster XS6500 Quick Installation

Quick installation
This section provides a brief overview
1
of a basic stand-alone installation of
the Sunmaster XS6500.
However; please review the entire manual for
additional features and connection diagrams and to
ensure best performance and years of trouble-free
service.
All electrical systems (DC and AC)
2
must be disconnected from any
power source during the entire
installation! Use isolated tools!
Read safety instructions (chapter 2
of the user's manual)
Fix the mounting bracket to the wall
3
Then place the Sunmaster over the mounting
bracket and then move it downwards until it is
locked by the mounting bracket
Loosen the two Phillips screws (a) and the two
4
clips (b) at the bottom side of the cabinet. Then
remove the bottom plate of the Sunmaster.
Mastervolt International B.V, P.O.Box 22947, NL-1100 DK Amsterdam, The Netherlands.
Sunmaster XS6500
.a
.b
See chapter 3.4 for specifications of the AC
5
wiring. Feed the AC wiring through the left
hand cable glad of the bottom plate and
connect the wiring to the screw terminals
Close the connection compartment; Steps:
6
1 Tighten the two Philips screws (a)
2 Tighten the cable glands (b)
See chapter 3.6 for specifications of the solar
7
system. Make sure the DC-Switch is in the
OFF position. Then connect the string cabling
to the Sunmaster
Please turn page for commissioning instructions
Tel.: +31-20-3422100 Email: info@mastervolt.com
English
a
b
SOLAR 1 SOLAR 2
Web: www.mastervolt.com v1.0 070507EN