Connections - Bush ELED22FHDS Instruction Manual

Connections

Bringing it all together
Connections
Connector
Connection
PC/YPbPr
AUDIO IN
Connection
Connection
(side&back)
SPDIF
(Coaxial Out)
Connection
Back AV
BACK AV
(Audio/Video)
Connection
HEADPHONE
Headphone
Connection
YPbPr Video
YPBPR
Connection
Connection
Connection
LAN
Ethernet
Connection
If you require any technical guidance or find that your TV is not operating as intended, a simple solution can often be found in the Troubleshooting section of these instructions,
14 Connections
Type Cables
VGA
(back)
Audio
YPbPr/PC Audio Cable
(back)
HDMI
SPDIF
(back)
Audio Video Cable
(back)
(side)
(back)
PC to YPbPr Connection Cable
USB
(side)
CI
(side)
LAN / Ethernet Cable
(back)
See the illustrations on the left side.
You can use YPbPr to VGA cable to
enable YPbPr signal via VGA input.
You cannot use VGA and YPbPr at the
Device
same time. To enable PC/YPbPr audio,
you will need to use the back audio
inputs with a YPbPr/PC audio cable
for audio connection. When using
the wall mounting kit (available from
a third party in the market, if not
supplied), we recommend that you
plug all your cables into the back of the
TV before mounting on the wall. Insert
or remove the CI module only when
the TV is SWITCHED OFF. You should
refer to the module instruction manual
for details of the settings. The/Each
USB input of your TV supports devices
up to 500mA. Connecting devices that
have current value above 500mA may
damage your TV. When connecting
equipment using a HDMI cable to your
TV, to guarantee sufficient immunity
against parasitic frequency radiation,
you have to use a high speed shielded
(high grade) HDMI cable with ferrites.
If you want to connect a device
to the TV, make sure that both
the TV and the device are turned off
before making any connection. After
the connection is done, you can turn
on the units and use them.