Cable Configuration; Connectors - NI SHC68-C68-D5 Installation Instructions Manual

3. Connect the other end of the cable to your supported NI high-speed DIO device. Refer to Table 1
in the Cable Configuration section to determine how to connect signals to your application.
1
1 NI SHC68-C68-D5 Connectors
2 Thumbscrews
4. Tighten the thumbscrews on the cable.
5. If you have not already done so, connect the NI 2515 to the rest of your system. Refer to the
NI Switches Help for more information about connecting the NI 2515 to your system.

Cable Configuration

Connectors

The cable connects two 68-position male VHDCI connectors. The connector labeled CONNECTS TO
NI 2515 provides connection to the switch module. The second connector provides connection to a
supported NI high-speed DIO device. Figure 3 shows the pinout for the connectors.
Use the pinout and the pin assignments listed in Table 1 to determine how to connect signals to your
application using the NI SHC68-C68-D5 cable.
© National Instruments Corporation
2 3
30 VDC CAT I
Figure 2. NI SHC68-C68-D5 Cable
Pin 1
Pin 35
Figure 3. NI SHC68-C68-D5 Mating Connector
CONNECTS TO NI 2515
3 Connects to Supported NI High-Speed DIO Device
4 CONNECTS TO NI 2515 Label
Pin 34
Pin 68
3 NI SHC68-C68-D5 Cable Installation Instructions
4 2 1