Sensio Luce Installation Instructions

InstallatIon
InstructIons
IMPoRTANT: please read these instructions before commencing installation and retain for future reference.
Components
4 x LUCE lED lights

Important safety information

Please read these instructions carefully before attempting to install
this product. It is advisable to keep these instructions in a safe place
for further reference.
We recommend that you consult a qualified electrician. All
electrical installations must be carried out in accordance with
current Iee wiring regulations (BS7671).
these products must not be modified, if any modifications are
made, it may invalidate the warranty and may render the product
unsafe. these lED lights operate low voltage (12V).
do not wire the individual Led light fittings directly to the mains.
This product is for indoor use only.

Safety instructions

1. Before commencing installation or maintenance, isolate the main
electrical supply for the appropriate circuit at the fuse board.
2. this product is only suitable for connecting to a 240V 50Hz supply.
the light should be mounted onto a secure surface.
3. never exceed the total output of the lED driver (4W).
4. suitable for furniture lighting.
Waste electrical & electronic equipment (Weee)
the symbol on the product, or on the document accompanying the product, the crossed out
wheelie bin symbol, indicated that this product may not be treated as household waste.
Instead it shall be handed over to the applicable collection point for the recycling of electrical and
electronic waste.
LUCE - SLS LED
PLINTH LIGHT KIT
CODE: 06.1110.0110
1x 13a Plug Driver and lED
cable connector
1 x Fitting Instructions
• If in doubt installation must be carried out by a qualified
electrician.
• Install on smooth flat surface(s) only.
• Do not exceed or stretch the cable length of each lED wire.
• this product is IP44 rated
•
Each fitting runs at 0.18W. The driver in this pack has a maximum
allowance of 4W.
5. When the lamp expires the fitting must be replaced.
6. class III safety extra low voltage (sElV)
7. A maximum of 22 fittings can be run from the driver in this pack.
Tools required
Power Drill
44mm screw Bit