Troubleshooting - Fridababy BreatheFrida FB9080 User Manual

TROUBLESHOOTING GUIDE:
CHECK THE FOLLOWING IF YOUR HUMIDIFIER IS NOT WORKING
CORRECTLY:
PROBLEM SOLUTION
Water vapor and
Power plug - unplug cord from Humidifier + try
humidity are not
again.
produced.
Power failure - when power is restored, try again.
Tank installation - make sure tank is attached
correctly.
The surface of the transducer is dirty - wipe with
soft cloth.
Air blows but water Excessive water - remove a cup of water from the
vapor is not produced. tank.
Dirty tank - wash out tank and try again.
Dirty Transducer - wipe the Transducer with a soft
cloth. If you have hard water in your home, try
using distilled water.
The water tank is not properly connected to the
base - place the tank onto the base properly so
that there is no gap between the tank + base all
the way around.
Humidity level is The surface of the Transducer is dirty - Wipe the
low. Transducer with a soft cloth.
The water in the unit is too cold - replace with
cool, but not cold, water.
The mist has a bad Poor maintenance or dirty water - clean the tank
smell. + base thoroughly according to instructions on
page 10-11 and fill with fresh water.
White dust is Hard water may deposit a dust-like residue. In
forming on nearby addition, dust in the air may settle due to the
furniture. added humidity in the room. If this becomes a
nuisance, use distilled water.
14
PROBLEM SOLUTION
Unit has stopped Low to no water - unplug unit and refill tank.
working.
Water is Saturation of humidity - lower mist control
accumulating setting.
outside of unit or
area surrounding Unit not level - unplug and place on level
unit. surface.
Point spray away from objects.
Raise unit on a water-resistant level surface 2-3
feet off of floor.
Water dripping Loose cap - tighten cap by turning all the way in
when refilling. a clockwise direction.
Water remaining on bottom of tank - wipe tank
or tilt to drain before transporting.
Increased noise Unit on uneven surface - unit must be placed on a
level. flat, hard surface. Make sure it is NOT placed on a
soft or absorbent surface.
Blue light flashing Indicates low water - unplug and refill tank.
three times.
No reaction when The water tank is not properly connected to the
the Light Control base - place the tank onto the base properly so
Button is pressed. that there is no gap between the tank + base all
the way around.
The power adapter is not inserted properly.
Reinsert the adapter into both the base + outlet.
15