Security And Password - Fluke Calibration 9190A Getting Started

Security and Password

The Calibrator has two user-level access security levels (Low and High) to protect from
undesired changes to the settings (see Table 8). The Calibrator comes from the factory
with the security level set to High and a default password of "1234".
If the password is not available, the information can still be viewed. To view the
information without the password, push  twice or push  when prompted for the
password. The information is then shown on the screen, but cannot be changed.
The Calibrator does not have a password reset function. If the password is
lost, contact Fluke Calibration for password reset assistance.
Security Level
Protects the specific metrological information and calibration information settings.
Low
Protects all operating parameters. It is intended to minimize user choices, for example,
High
to perform repeated identical calibrations under consistent conditions.
To change the password:
1. Push .
2. Push .
3. Push .
4. Enter the current 4-digit password to open the password screen (the default factory
password is
5. Push  and  to highlight a digit then push  to increase the digit or push  to
decrease the digit.
6. Push  to save the password.
To change the security level:
1. Push .
2. Push .
3. Push .
4. Enter the current 4-digit password to open the password screen (the default factory
password is
5. Push  and  to highlight
6. Push  to save the selection.
Note
Table 8. Security Levels
1234
).
1234 ).
HIGH LOW
or
Definition
.
Ultra-Cool Drywell
Calibrator Setup
11