Pairing A Bluetooth Device - EDISON Professional EP-1000 Manual

Pairing a Bluetooth Device

1. Turn on your Bluetooth device. Press this button to enter
bluetooth mode.
2. The display "bt" will flash for a few of seconds and start-up sound
comes out,this means that it is ready for Bluetooth connection.
3. Activate the Bluetooth of the equipment to be connected.
4. Search for this Bluetooth soudbox
Enter the "Bluetooth setting" and carry out the "scan the
Bluetooth device"command. After being scanned, names of
"Edison EP1000"will be listed.
5. Match and confirm the connection
Choose the "Edison EP1000" Bluetooth device and it will be
automatically matched in the next several seconds.
The soundbox will release a short sound tip. if the display "bt" is
stop flash,It indicates that bluetooth has been connected
successfully. generally it ta kes only several seconds to complete
the Bluetooth connection ,and maybe longer time according to
the different bluetooth technology (some devices might require
to feed matching digits like "1234" or "0000" before connecting
successfully ).
6. Bluetooth automatical re-connection
After the renewal startup it will automatically search for and
connect the Bluetooth device connected last time. Please put
these two Bluetooth devices at the mutually-discernable
distance. if the re-connection fails, the display "bt" will flash, and
it will search for the Bluetooth device again .
7. Bluetooth Disconnection
Press Pairing Button , the Bluetooth will be disconnected , then
the display "bt" will flash , entering the status of Bluetooth-
searching .
Note: Maximum range will be achieved when using devices with
Bluetooth 4.0 or higher.
6