Important Safety Rules - DeWalt DC021 Operating Instructions Manual

EN GLIS H

Important Safety Rules

1. WARNING! When using the DC021 and
DC022 worklight/chargers, basic precautions
should always be followed, including the
following:
a. Read all the instructions before using the
DC021 and DC022 worklight/chargers.
b. To reduce the risk of injury, close supervision
is necessary when a worklight/charger is
used near children.
c. Do not contact moving parts.
d. Only use attachments recommended or sold
by the manufacturer.
e. Do not use outdoors.
f. To disconnect, turn all controls to the off
("O") position, then remove plug from outlet.
g. Do not unplug by pulling on cord. To unplug,
grasp the plug, not the cord.
h. Unplug from outlet when not in use and
before servicing or cleaning.
i. Do not operate any worklight/charger with a
damaged cord or plug, or after the worklight/
charger malfunctions or is dropped or
damaged in any manner. Return worklight/
charger to the nearest authorized service
facility for examination, repair, or electrical or
mechanical adjustment.
j. To reduce the risk of electrical shock, do not
put worklight/charger in water or other liquid.
Do not place or store worklight/charger
where it can fall or be pulled into a tub or
sink.
k. Use only the charger supplied by the
manufacturer to recharge.
l. Always unplug before replacing the bulb.
Replace bulb with same type rated 38 Watts.
m. Connect to a properly grounded outlet. Refer
to Grounding Instructions.
Safety Rules for Worklight/Chargers
WARNING: Burn hazard. Do not
operate flashlight or charger near
flammable liquids or in gaseous or
explosive atmospheres. Internal sparks
may ignite fumes causing personal
injury.
WARNING: Shock hazard. Remove
battery pack before replacing the
fluorescent bulb.
24
• Vision may be impaired when looking directly
into fluorescent light.
• Do not expose light or charger to wet or damp
areas. Do not expose light or charger to rain or
snow.
• Do not wash light or charger with water or
allow water to get inside light or charger. Do
not submerge light in water at any time.
• Do not operate without lens cover assembly
attached.
• Before using battery and charger, read all
instructions and cautionary markings on
charger, battery pack, and product using battery
pack.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities, or lack
of experience and knowledge, unless they have
been given supervision or instruction concerning
use of the appliance by a person responsible for
their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
DANGER: Electrocution hazard.
230 volts are present at charging
terminals and outlets of the DC022.
115 volts are present at charging
terminals of the DC022LX. Do not
probe with conductive objects. Electric
shock or electrocution may result.
WARNING: Shock hazard. Do not allow
any liquid to get inside worklight/charger.
Electric shock may result.
CAUTION: Burn hazard. To reduce
the risk of injury, charge only D
rechargeable batteries. Other types of
batteries may burst causing personal
injury and damage.
CAUTION: Under certain conditions,
with the worklight/charger plugged
in to the power supply, the exposed
charging contacts inside the charger
can be shorted by foreign material.
Foreign materials of a conductive
nature such as, but not limited to, steel
wool, aluminum foil, or any buildup of
metallic particles should be kept away
from charger cavities. Always unplug
the charger from the power supply
when there is no battery pack in the
cavity. Unplug worklight/charger before
attempting to clean.
WALT
E