Related Manuals for Weldman MISTRAL MIG 200
Summary of Contents for Weldman MISTRAL MIG 200
- Page 1 WELDMAN MISTRAL MIG 200 INSTRUCTIONS MANUAL WARNING! FOR SAFETY REASON PLEASE READ AND UNDERSTAND THE FOLLOWING INSTRUCTIONS BEFORE FIRST USE OF THE DEVICE.
-
Page 2: General Instructions
1. General instructions Read the operating instructions! The operating instructions provide an introduction to the safe use of the products. An incorrectly performed installation can result in material damage and injure persons as a result. For this reason, we do not accept any responsibility or liability for losses, damages or costs arising from incorrect installation, improper operation or incorrect usage and maintenance or any actions connected to this in any way. -
Page 3: Safety Instructions
2. Safety instructions DANGER! Electromagnetic fields! The power source may cause electrical or electromagnetic fields to be produced which could affect the correct functioning of electronic equipment such as IT or CNC devices, telecommunication lines, power cables, signal lines and pacemakers. •... - Page 4 WARNING! Smoke and gases! Smoke and gases can lead to breathing difficulties and poisoning. In addition, solvent vapour (chlorinated hydrocarbon) may be converted into poisonous phosgene due to the ultraviolet radiation of the arc! • Ensure that there is sufficient fresh air! •...
- Page 5 CAUTION! Installation site! The machine must not be operated in the open air and must only be set up and operated on a suitable, stable and level base! • The operator must ensure that the ground is non-slip and level, and provide sufficient lighting for the place of work.
-
Page 6: Technical Specification
3. Applications WELDMAN MISTRAL MIG 200 is intended for welding processes like MIG/MAG, MMA, TIG Lift and FLUX. The device is made for arc welding of steel alloys in all methods, and aluminium alloys in mig mode only. The manufacturer is not liable for damage caused by improper use of the device. - Page 7 5. Preparing device to work If the device is stored or transported in cold conditions it must be brought to a temperature above zero before starting work.
- Page 8 5.1 Connecting torches and cables Place the device on an even and dry surface in a ventilated room with good air circulation away from flammable objects. Avoid contact of the inner components with dust, corrosive vapors, moisture, direct rain, welding spatter, grinding dust etc. CONNECTING TO POWER SUPPLY NETWORK Before connecting to power supply make sure that supply network parameters correspond to the voltage and frequency of the device.
- Page 9 6.1.3 TIG PROCESS • turn on the main switch on the rear panel of the welding machine • set the welding method switch in the MIG / TIG position (5) • set the desired welding current (8) • we start welding Lift arc ignition a) Touch the welded surface with the tip of the tungsten electrode b) Lean the torch downwards to brake a contact with work piece until arc develops...
-
Page 10: Troubleshooting
7. Troubleshooting 8. Transporting and storage Always store the devices in a dry, ventilated place, out of reach of children and bystanders. Protect the device against vibrations and shocks during transport. 9. Recycling The packaging and device materials are suitable for recycling use. Disposal of the packaging and device must be done in accordance with local regulations.
Need help?
Do you have a question about the MISTRAL MIG 200 and is the answer not in the manual?
Questions and answers