System Set Up/Remote Control - Taga Harmony inTONE 2.1 Introduction Manual

System Set-UP
Rear Panel of Subwoofer
Remote Control
SET
1:INPUT : Press this button to choose one of audio sources
2: : Press this button to turn on/off the speaker unit
3:EQ: Press this button to choose different sound effect
4:REPEAT: Press this button to re-play the audio file
5:MUTE: Press this button to turn off the sound of inTONE 2.1
6: / : Press this button to choose PREV or NEXT track
VOL+/VOL-: Press this button to increase or decrease
the volume of inTONE 2.1
7: :To start playback, press this button; To pause playback, press this button
again; to resume playback,
Note: Functions REPEAT; PREV/NEXT; PLAY/PAUSE work only with
devices or USB drives and SD/MMC cards. Some of the functions could not be
available for all devices.
5
Control Panel -LED Display
1:RCA Audio Input
2:Speakers Output
3:3.5mm Aux-in Jack
4:Power Switch
5:AC Power Socket
6:SD/MMC Card Slot
7:INPUT/FN Button
8:VOL+ Button
9:VOL- Button
10:USB Port
11: IR Sensor
12:PLAY/PAUSE Button
13:PREV Button
14:NEXT Button
press this button again
Bluetooth
Remote Control Instructions:
Battery installation:
14
Operating the range of remote control: use the
remote control within a range of 7 meters
and angles of up to 30 degrees aiming at the
remote control sensor.
Caution:
Always use CR2025L Lithium batteries, and do not use the rechargeable batteries.
If the battery run out, remove the old battery and replace it with new one
within several minutes.
If the battery is placed incorrectly, it can cause explosion.
Remove the battery if the remote control is not used for a long period of time.
Do not handle and store the battery with metallic tools.
Connection of the subwoofer with the
satellites
Make sure the POWER switch is in OFF position(the subwoofer is switched off).
Using the supplied subwoofer-satellite speaker interconnect cables connect
SPEAKER OUT R on the rear of the subwoofer with SPEAKER IN on the rear of
your Right inTONE 2.1 satellite, and then connect your Left satellite using
SPEAKER OUT L.
Power on subwoofer by changing the position of the POWER switch to ON.
Your system is ready to use.
SPEAKER
IN
Right
CARD
INPUT/ FN
VOL+
VOL-
-
SPEAKER
USB
PLAY/PAUSE
PREV
NEXT
IN
Left
6