Internal Repeater Installation Toro E Osmac Satellite Plastic Pedestal - Toro Turf Guard Installation Setup Manual

Internal Repeater Installation - Toro E-OSMAC Satellite - Plastic Pedestal
To complete this installation, you will need an internal repeater, a power conversion board (to tie into the
E OSMAC's 13 VAC power supply), and a 3/4" (19mm) #10 sheet metal screw.
Step 1 Turn the power source OFF to the E OSMAC satellite controller and remove the front plastic door.
Step 2 Detach the top circuit board. See Figure 15.
Step 3 Connect the power conversion board to the power source.
Step 4 Reattach the circuit board.
Step 5 Mount the conversion board on the inside wall of the pedestal using the adhesive back.
Step 6 Mount the repeater on the inside wall opposite the conversion board using a 3/4" (19mm)
#10 sheet metal screw.
Step 7 Connect the repeater to the conversion board.
Step 8 Turn the power source back ON to the satellite.
Step 9 Record the repeater ID and location in the Installation Log.
Step 10 Proceed to the Internal Repeater Startup Procedure section.
Figure 15
8