Registering Handsets - Siemens Gigiaset SL37H Manual

Registering handsets

A Gigaset SL37H handset can be registered
to up to four base stations.
Once it has been registered, the handset
returns to idle status. The internal number of
the handset appears in the display, e.g. INT
1. If it does not, repeat the procedure.
On the handset
¢ ¢
w Ð
Handset
s
Select base station, e.g. Base 1
and press
~
Enter the system PIN of the base
station (the default is 0000) and
§OK§
press . The following flashes
in the display, e.g. Base 1.
On the base station
To find out how to register the handset to
the base station, see the user guide for the
base station.
Placing the handset in the
charging cradle
¤
Plug the charging cradle mains adapter
into a mains power socket.
¤
Place the handset in the charging cradle
with the display facing forward.
To charge the battery pack, leave the hand-
set in the charging cradle.
Please note:
– If the handset has switched itself off because
the battery pack is flat and is then placed in
the charging cradle, it will switch itself on
automatically.
– Only place the handset in the charging cradle
that is intended for it.
For questions and problems
¢
Register H/Set
§OK§
.
¢
S. 29.
Initial charging and discharging of
the battery pack
If the handset is activated, the flashing bat-
tery icon e in the top right of the display
indicates that the battery pack is being char-
ged.
During handset operation, the battery icon
indicates the charge status of the battery
¢
pack ( S. 1). The correct charge status can
only be displayed if the battery pack is first
fully charged and discharged.
¤
To do this, leave the handset in the char-
ging cradle continuously for ten hours.
Your handset need not be switched on
for it to charge.
¤
Afterwards, remove the handset from the
charging cradle and do not put it back
again until the battery pack is fully
discharged.
Please note:
After the first battery charge and discharge, you
may place your handset in the charging cradle
after every call.
Please note:
u
Always repeat the charging and dischar-
ging procedure if you remove the battery
pack from the handset and insert it again.
u
The battery pack may warm up as it is
charging. This is not dangerous.
u
After a time the charge capacity of the
battery pack will decrease for technical
reasons.
7