Samsung TDM PLUS Service Manual page 67

Error code related to the Communications / Settings / HW
CODE
E-464 Error due to over-current of inverter compressor 1
E-465 V-limit error of inverter compressor 1
E-466 Error due to over voltage /low voltage of Inverter PBA1
E-467 Error due to unconnected wire of compressor 1
E-468 Output current sensor error of inverter PBA1
E-469 DC voltage sensor error of inver PBA1
E-470 Outdoor EEPROM data checksum error
E-471 Error due to the INV1 Data Flash
E-475 Outdoor fan 2 error
E-484 PFC overload error
E-485 Error due to input current of inverter 1
E-500 Error due to overheat caused by contact failure on IPM of Inverter PBA1
E-554 Gas leak error
E-590 Inverter EEPROM loading error
E-601 Communication error between the Hydro Unit and wired remote controller
E-604 Communication tracking error between the Hydro Unit and wired remote controller
Wired remote controller
E-653
temp sensor SHORT or OPEN
Memory(EEPROM) Read
E-654
Write error(Wired remote controller data error)
E-702 Error due to closed EEV of indoor unit (1st detection)
E-703 Error due to opened EEV of indoor unit (1st detection)
E-901 Water inlet (PHE) temp sensor error (Short/Open)
E-902 Water outlet (PHE) temp sensor error (Short/Open)
E-904 Water tank temp sensor error (Short/Open)
E-906 Refrigerant gas inlet temp sensor error (Short/Open)
E-911 Flow switch open error
E-912 Flow switch close error
E-914 Thermostat wrong connection error
E-916 Mixing valve temp sensor error (Short/Open)
Samsung Electronics
Explanation
67