Nautilus T914 Technical Bulletin

Belt adjustment / belt tracking

Hide thumbs Also See for T914:

Product Technical Bulletin

from Nautilus

Nautilus Treadmills

Belt Adjustment / Belt Tracking

Treadmill Belt Adjustment

Nautilus Treadmill Models

T912

T914

T916

You will need a 13mm Metric Socket.

Test the belt tension by running on the belt at about 4-mph. Hold the handrail lightly and resist the

belt movement with your feet. If you feel the belt slip on the front roller, then increase the tension of

each adjustment bolt by 1 turn and retest. Be sure to count your turns and tighten evenly.

Table of Contents

Do you have a question about the T914 and is the answer not in the manual?

Page 1 Product Technical Bulletin from Nautilus Nautilus Treadmills Belt Adjustment / Belt Tracking Treadmill Belt Adjustment Nautilus Treadmill Models T912 T914 T916 You will need a 13mm Metric Socket. Belt Tension Test the belt tension by running on the belt at about 4-mph. Hold the handrail lightly and resist the belt movement with your feet.
Page 2 Product Technical Bulletin from Nautilus Treadmill Belt Tracking Perform this procedure whenever the belt moves to one side or the other. Stay off the belt when adjusting the tracking. Start the treadmill at minimum speed and incline. Increase speed to 5 mph and make the following adjustment. The figure above shows the location of the bolts: If the belt moves to the right, turn the right tension bolt 1/4-turn clockwise.

T916 T912