Your new Subwoofer has been factory configured for 120 volt AC lines. Connecting the Ultra-X12 to a line voltage other than that for which it Retain Instructions The safety and operating instructions should be ¼...
Product to Outlaw. We will pay the return shipping ® Outlaw Audio, LLC. *This warranty is limited to ninety (90) days from the date of original purchase for any Outlaw Audio product that is used for professional or commercial purposes, or any other income-producing purpose.
Before you Begin The Outlaw Model Ultra-X12 is a state of the art, high per- After unpacking your subwoofer please confirm that the formance, powered subwoofer. It is built utilizing totally following accessories have been included.
Outlaw Ultra-X12, can provide a vis- to deliver the full spectrum of sound from a system. ceral impact that most speakers are not able to provide on In the era of digital, multi-channel sound, many listeners their own.
MASTER POWER Switch automatically when an audio signal is present. SUB IN EXTERNAL X-OVER Jack Use this switch to turn the AC power to the Ultra-X12 Port Switch Connect the subwoofer output of your receiver, subwoofer on or off. If the unit will not be used for an Toggles the Ultra between “Max Output”...
Make sure the rods are threaded all the way in. For your convenience we have provided “dimpled discs” Do not attempt to operate the Ultra-X12 unless the Screw a spike foot into the threaded hole in each ¼...
¼ with a Subwoofer/LFE preamp output and an inter- with a Subwoofer/LFE preamp output, but without SUB IN jacks on the rear panel of the Ultra-X12 to connect nal crossover: an internal crossover: to your Preamp/Processor or Receiver. Any audio device that...
Make sure to observe correct polarity by connecting the same half of the speaker Employer uniquement avec un fusible de 250v FUSE cable to the red (+) and black (–) terminals between the amplifier and Ultra-X12. 120V - 60HZ T 5A L 250V...
Once all connections have been made, connect the supplied Before powering on the Ultra-X12, ensure that all the power cord to the AC Input on the rear panel of the Ultra-X12 audio and AC power connections made to the subwoofer...
POWER INDICATOR LED glows red To turn the Ultra-X12 on and off automatically By adjusting the crossover frequency between the Ultra 10Hz above the lowest frequency your main speakers can ¼...
Depending upon the phase of your speakers, including the Ultra-X12, make sure your receiver or processor is con- or processor, make sure it is connected to the Ultra-X12’s subwoofer, in relation to the listening position, the bass nected to the Ultra-X12’s SUB IN INTERNAL X-OVER jacks or SUB IN EXTERNAL X-OVER jack.
¼ Ultra-X12 subwoofer has two available “tuning” modes. to match the output of the Ultra-X12 with the rest of your Sitting in your favorite listening seat, turn on the SPL When the PORT MODE switch is set to MAX OUTPUT, your speakers.
Finding the best location Finding the best location for your subwoofer for your subwoofer Placement lacement of your Ultra-X12 subwoofer is a critical component in maximizing its performance. The subwoofer’s specific location in a room influences its “perceived” frequency response, Avoid having the...
Need help?
Do you have a question about the Ultra-X12 and is the answer not in the manual?
Questions and answers