Quick Info (Limited Tools Menu); To Recover The Pin Code - Husqvarna Automower 420 Workshop Manual

If ultrasonic has been turned off from
Ultrasonic , the product will continuously operate at
reduced speed 46 cm/s / 18 in./s.
Loop sensitivity : The sensitivity can be set to
•
Normal or High .
4.4.6 Tools - Calibrate
Tools - Calibrate menu shows:
The
Guide calibration : The guide wire is calibrated
•
automatically during the first start-up sequence. A
manual calibration may however be necessary, if for
example the charging station installation is changed.
Place the product in the charging station and start
the calibration.
Tilt sensor calibration : If the product does not
•
operates as expected in slopes it might help to
calibrate the tilt sensor. Place the product on a
horizontal surface and start the calibration.
Cutting height calibration : The cutting height
•
calibration can be enabled and the calibration set to
start the next time the product starts.

4.5 Quick info (Limited Tools menu)

Quick info menu is a limited Tools menu .
The
When the start page or the main menu is displayed:
1. Push and hold down the 0 key for 2 seconds to
Quick info menu.
access the
4.5.1 Quick info - Info
Quick info - Info menu has the same sub-menus as
The
Tools , except for the sub-menu Motors and GPS
in
navigation . Refer to Tools - Info on page 10 .
4.5.2 Quick info - History
Quick info - History menu has 2 sections: Messages
The
Search times .
and
The History - Messages menu shows:
Fault messages : The 50 last fault messages
•
Info messages : The 50 last information messages.
•
History - Search times menu show the same sub-
The
Tools - History, total - Search times . Refer
menus as in
Tools - History, total - Search times on page 12 .
to
4.5.3 Quick info - Advanced
Quick info - Advanced menu shows:
The
Automatic passage handling : The guide corridor
•
width is adjusted automatically. If
handling is disabled, the corridor width settings must
be made manually. To disable the
handling : Unselect Auto passage handling and push
the OK button.
Installation shape :
•
Open : Applicable in a large open work area with
•
a small number of obstacles and no passages,
or when the mowing result is uneven in steep
slopes.
14 - Special menus 420/430X/430XH/
440/450X/450XH
Accessories -
•

4.6 To recover the PIN code

1. In the input mode for PIN code, hold down the 9
2. Speak to the local sales support and tell them the
3. Push the Back button to exit the function.
Auto passage
Auto passage
Normal : Applicable in a work area with a
•
moderate number of obstacles and/or passages.
Applicable for most work areas.
Complex : Applicable in work areas with many
•
obstacles and/or passages.
Calibrate : It has the same submenus as in Tools -
Calibrate . Refer to Tools - Calibrate on page 14 .
button for 3 seconds. A combination of 12 letters
and the serial number of the product will be shown in
the display.
Note: If the product is locked because of an
incorrectly entered PIN code, you must wait before
you try again. The letter combination can be different
if you try again with the same product and with the
same PIN code.
letter combination and serial number. They can then
identify the right PIN code.
1191 - 001 -