Craftsman 33393 Operator's Manual page 2

No hardware incJuded
Lever Styme = Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Putt out to remove.
Chest:
Literature
TO ATTACH CHEST
Process:
. Remove enough drawers to access the top and bottom
mounting surfaces of the units. See Operation Section,
Part B.
. Place the chest in the desired location on top of the cabi=
net or intermediate chest and mark the mounting hole
locations onto the cabinet top.
. Remove the chest and drill two 5116" (8mm) holes
through the top of the cabinet or intermediate chest.
. Secure the units together using two 114= 20 x 518"
screws and nuts at each joint. The hardware is provided
in the bag located in the top tray of the chest.
. Reinstall drawers. See Operation Section, Part C.
NOTE: Not att operation instructions witt relate to your
model.
TO LOCK CHEST
Process:
o Make sure drawers are fully closed.
o insert the tockbar (which stores in the top tray), tabbed
end up, into the stot in the top tray and down into the stot
in the base.
o Close the cover and tock with the key.
TO UNLOCK CHEST
o Reverse above procedure..
REMOVING DRAWERS
o Empty the drawer.
o Fully extend the drawer.
Release
/
iNSTALLiNG DRAWERS
BaH bearing stide = Putt slides and slide carrier out to fully
extended position (see illustration.) Hotd the slide on the
cabinet white aligning it with the stide on drawer. Slightly
insert one side and repeat for the other side. Stowty push
drawer to its fully closed position to engage slide. Open
drawer and rectose to ensure proper operation.
slide carrier
' Gi
slide
\\
\
\
\