Sunbeam SB08 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Sunbeam Manuals
  4. Sewing Machine
  5. SB08
  6. Operating instructions manual

Sunbeam SB08 Operating Instructions Manual

Mini sewing machine
Hide thumbs

Advertisement

Table of Contents

Sunbeam Mini Sewing Machine
Operating Instructions
Model No. SB08
Read all instructions carefully before using this item
SMT122911

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the SB08 and is the answer not in the manual?

Questions and answers

Related Manuals for Sunbeam SB08

Summary of Contents for Sunbeam SB08

  • Page 1 Sunbeam Mini Sewing Machine Operating Instructions Model No. SB08 Read all instructions carefully before using this item SMT122911...

  • Page 2: Component Identification

    Component Identification...

  • Page 3: Threading The Machine

    1. Needle Clamp 9. On/Off Switch 2. Bobbin Compartment 10. Speed Button 3. Needle 11. Battery Compartment 4. Take-up Lever 12. DC Jack 5. Tension Screw 13. Foot Pedal Jack 6. Thread Spindle 14. Presser Foot Lever 7. Bobbin Holder 15.

  • Page 4: Bottom Bobbin Placement

    1. Raise thread spindle by pulling it upward until it’s fully extended. 2. Place thread spool on the thread spindle. (for bobbin spindle: pull out the spindle and guide it through the hole in the bobbin and replace the spindle) 3.

  • Page 5: Sewing Instructions

    Sewing Instructions: 1. Lift the needle above the presser foot by turning the hand wheel slightly in clockwise direction. 2. Raise the presser foot by lifting up on the lever in back of the machine above the presser foot bar. 3.

  • Page 6: Changing Needle

    Changing Needle: 1. Turn the hand wheel clockwise to raise the needle to its highest position. 2. Loosen the needle clamp screw by turning it counter clockwise. You may need to use a short slotted screwdriver or small piece of metal (e.g. dime). 3.

  • Page 7: For Your Safety

    For Your Safety:  Always disconnect or remove power supply including batteries when changing needles or threading machines  Never open the main motor case of the machine. The mechanism has been factory adjusted.  Always check the threading of the lockstitch before beginning to sew a seam. Improper threading or placement of the bobbin will result in damage to the machine and clothing.
  • Page 8 6 Months Limited Warranty The SB08 Mini Sewing Machine is warranted for 6 months from provable date of purchase against defects in material and workmanship. During this period such defects will be repaired, or the product will be replaced without charge.

Table of Contents

Save PDF