Removing Drawers - Craftsman 33394 Operator's Manual

REMOVING DRAWERS
oEmpty t hedrawer.
Fully e xtend t hedrawer.
Release
®
REMOVING AND iNSTALLiNG SLIDES
. To remove the slide from the unit, first remove the
drawer.
oAfter removing the drawers drill out the rivets, use a 5132-
in dritt bit. The rivets witl need to be replaced.
oTo reinstall the slide, place the slide in the appropriate
position in the unit and putt toward the front of the unit.
Replace rivets to secure slide to the unit.
o For smooth operation, make sure the drawers are
matched with their originat slides.
\
Lever Style = Lift or lower (depending on the slide) the
release lever on both sides, (this allows the slides to ride
over the stops.) Putt out to remove.
/
iNSTALLiNG BRAWERS
BaH bearing shale = Putt slides and slide carrier out to fully
extended position (see illustration.) Hotd the slide on the
cabinet while aligning it with the slide on drawer. Slightly
insert one side and repeat for the other side. Slowly push
drawer to its futty closed position to engage slide. Open
drawer and rectose to ensure proper operation.
slide carrier
/
i
@
REMOVING AND iNSTALLiNG SLIDES FROM UNtT
o First remove the drawer. (See section A)
To remove the slide:
o Push slide to the ctosed position.
o insert flat tip screw driver between stide and unit, behind
rear rectangular cutout.(See illustration.)
o Rotate screw driver ½ turn to force stide away from unit.
o Push on front of slide pushing it towards back of the unit.
\
\,
\
To attach the slide:
- Extend stide and locate lances within respective
cutout in carrier.
- Putt slide forward until slide locks back into place.
o Reinstall drawer following drawer installation proce-
dure.(See section B)