Bio Green Frosty 2500 Installation And Operating Instructions Manual page 11

Gewächshausheizung Frosty 2500 / Frosty 4500
• In a greenhouse, position the apparatus where good air circulation is ensured.
• We recommend installation approx. 20-30 cm above the floor.
• This apparatus is not suited for orchid and succulent rearing, since some orchids and
succulents cannot tolerate CO
plants can handle CO
• Attention! The enclosure heats up when in operation! Allow to cool down before
transporting.
• Attention! Close the cylinder valve immediately in case of uncontrolled gas leakage.
4. Assembly and connection of the heater to the gas cylinder
Depending on application, screw the two supplied brackets to the bottom (upright heater, see
Fig. 1a) or to the back (wall heater, see Fig. 1b) before connecting the apparatus. The distance
between mounting holes is 328 mm for the Frosty 4500 wall heater and 228 mm for Frosty
2500.
Figure 1a
Before connecting the apparatus, check that the local supply (gas type and gas
pressure) matches the settings of the apparatus. The specified values for the apparatus
are shown on its nameplate. This apparatus is not connected to a waste gas draw off. It
must be set up and connected according to the locally applicable installation
requirements. Especially ensure suitable ventilation.
enrichment. If you are not sure whether your greenhouse
2
enrichment, ask a gardener.
2
11
Figure 1b