Stanley J5C09 Instruction Manual
500 amp battery with compressor
Hide thumbs
Also See for J5C09:
- Instruction manual (6 pages) ,
- Instruction manual (42 pages) ,
- User manual
Related Manuals for Stanley J5C09
Summary of Contents for Stanley J5C09
- Page 1 500 Amp BATTERY jump-sTARTER WiTh CompREssoR iNsTRuCTioN mANuAl J5C09 SAVE THIS INSTUCTION MANUAL FOR FUTURE REFERENCE.
-
Page 2: General Safety Warnings And Instructions
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may TURES not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. - Page 3 • Stay alert. Watch what you are doing. Use common sense. Do not operate appliance when you are tired. Do not operate compressor continuously for longer than approximately 10 minutes, depending on ambient temperatures, as it may • Check for damaged parts. Any part that is damaged should be replaced by the manufacturer before further use. overheat.
-
Page 4: Jump-Starter
• Do not use this jump-starter on a watercraft. It is not qualified for marine applications. Note: In the rare event that the vehicle to be started has a Positive Grounded System (positive battery terminal is connected to chassis), replace steps 4a •... -
Page 5: Care And Maintenance
4. Turn on the Compressor Power Switch. Unit Fails to Jump-Start 5. Check pressure with the pressure gauge. • Make sure unit’ s power switch is in the on position. 6. When desired pressure is reached, open thumb latch and remove the SureFit™ nozzle connector from the valve stem. •...
Need help?
Do you have a question about the J5C09 and is the answer not in the manual?
Questions and answers
How to change jump starter battery J5cos
The context does not provide step-by-step instructions on changing the battery in a Stanley J5C09 jump starter. However, based on the available information, the jump starter uses a 12V 22AH sealed lead acid battery (SigmasTek SP12-22 NB). To replace the battery, follow these general steps:
1. Turn Off and Disconnect – Ensure the jump starter is turned off and unplugged from any power source.
2. Open the Unit – Locate and remove screws or clips securing the casing.
3. Remove the Old Battery – Disconnect the positive and negative terminals carefully.
4. Install the New Battery – Connect the new 12V 22AH battery, ensuring correct polarity (positive to positive, negative to negative).
5. Reassemble the Unit – Secure the casing back in place.
6. Test the Jump Starter – Turn it on to confirm proper operation.
Always follow safety precautions and refer to the user manual for exact instructions.
This answer is automatically generated
Compressor no air coming out.
There may be no air coming out of the Stanley J5C09 compressor due to one or more of the following reasons:
1. The compressor may have overheated and automatically shut down. If this occurred, turn off the compressor and allow it to cool for about 30 minutes before restarting.
2. The unit may be out of battery. The compressor can fill up to 3 average-sized tires before needing a recharge. Ensure the unit has a full charge.
3. The power switch may be off. Make sure the compressor's On/Off switch is in the "On" position.
4. The hose or fittings may be improperly connected or blocked. Check that the compressor hose is properly attached and not obstructed.
5. The compressor may be damaged, especially if smoke was previously observed. In this case, internal components may be failing.
This answer is automatically generated