Table of Contents
Advertisement
English
WARNING: To minimize the risk of eye injury, always wear ANSI Z87.1 approved eye
protection and respiratory protection when performing this.
NOTICE: The corded power supply is for AC power sources only when used with
a tool. Use with DC power sources could result in damage to the tool.
To install the corded power supply into your tool
•
With the corded power supply unplugged, align its AC connector
corded power supply receptacle (
•
Ensure that it is fully seated in the tool and does not disengage.
•
If applicable, attach the dust cover
power supply.
•
Secure the cord clip
the clip into the holder.
•
With the tool turned off, plug the corded power supply into a standard 230 V household
electric power outlet. UK 115V units should be plugged into a 115V transformer. Do not
attempt to use the corded power supply on any other voltage.
•
Use the tool according to the tool instructions, making sure the cord is located so that it
will not be stepped on, tripped over, or otherwise subjected to damage or stress.
•
To remove the corded power supply from the tool (Fig. B), first unplug the corded
power supply from the outlet, then press the release button
corded power supply out of the tool. If applicable, firmly press the end of the dust cover
4
into the tool's corded power supply receptacle
MAINTENANCE
The corded power supply is not serviceable. There are no serviceable parts inside the
corded power supply.
Do not attempt to repair the corded power supply. To assure product safety and reliability,
repairs, maintenance, and adjustments should be performed by authorized D
centers. Your D
WALT corded power supply has been designed to operate over a long
e
period of time with a minimum of maintenance. Continuous satisfactory operation depends
upon proper care and regular cleaning.
WARNING: To reduce the risk of serious personal injury, turn tool off and disconnect
battery pack before making any adjustments or removing/installing attachments or
accessories. An accidental start-up can cause injury.
8
5
, Fig. B) then snap into place.
to the dust cover holder (
4
into the tool's cord holder (
3
1
with the tool's
, Fig. C) in the corded
6
, Fig. D), if applicable. Firmly press
7
2
and firmly pull the
5
.
WALT service
e
Hide quick links:
Advertisement
Table of Contents
