Advertisement
Replacing the lamp unit and air filter (continued)
5) Attach the lamp unit cover.
z Close the lamp unit cover by the reverse
procedure from step 2), and use a Phillips
screwdriver to tighten the lamp unit cover
fixing screw (one screw).
• Make sure the connector at the side of
the lamp unit cover is firmly inserted in
the fan power connector.
• Make sure to attach the lamp unit cover
properly.
Note
z When you place the new lamp unit, the projector
resets the total usage time of the lamp unit
automatically.
Attention
z After unpacking the lamp unit, discard the
packaging material properly.
Replacing the air filter
1) Set the <MAIN POWER> switch to
<OFF> and disconnect the power
plug from the power outlet.
z Wait at least one hour and check if the lamp
unit has cooled down.
2) Remove the lamp unit cover.
z See step 2 of the "Replacing the lamp unit"
section.
3) Removing the air filter.
(i) Pull the air filter case out from the projector.
Air filter
6-ENGLISH
Air filter case
(ii) Remove the air filter from the air filter case.
• Hold the (a) section of the air filter, and
raise the filter while pushing it gently in
the direction of the arrow.
Air filter
Air filter case
4) Attaching the air filter.
(i) Align the marks (r) on sections (a) and
(b), and insert the tabs of the new air filter
into the air filter case in the direction of the
arrow.
(b)
(a)
(ii) Press the air filter in the direction of the
arrow, and insert the tabs securely.
• Make sure the tabs are secured firmly.
Air filter case
Air filter tabs
(b)
(a)
Air filter tabs
Air filter case
Air filter tabs
Advertisement
