Safety Alerts - IconBiT SMART SCOOTER User Manual

9. Safety Alerts

During operation, if there is a system error or illegal operation performed with your scooter, the system cannot enter self-balancing mode, so the device will prompt the
user in a variety of ways. You will notice the Running Indicator Light will turn RED and you will hear a beep sound alerting you to take precaution and cease operation. The
following are common occurrences where you will hear the Safety Alerts; these notices should not be ignored, but appropriate action be taken to correct any illegal
operation, failure or errors.
Prohibited riding surfaces (uneven, too steep, unsafe, etc.) When you step on the scooter, if the platform is tilted more than 10 degrees forward or backward. Battery
voltage is too low.
The device is still charging.
During operation, the platform self initiates to tilt due to excess speed.
Overheating, motor temperature is too high.
The device has been rocking back and forth over 30 seconds. System enters protection mode, the alarm indicator will light up and buzzer will alarm (this typically occurs
when the battery is about to die).
If the platform is tilted forward or backward more than 35 degrees, scooter will power o .
If the tire is blocked, scooter will stop after 2 seconds.
When the battery level has depleted below protection mode, the scooter engine will power o after 15 seconds.
While sustaining a high discharge current during operation (such as driving up a steep slope for a long period of time), the Scooter engine will power o after 15 seconds.
English 10 / 12