Controller Operation; Error Codes - Z GRILLS Feed Life ZPG-700E Series Owner's Manual

6. Controller Operation

The Controller monitors the Temperature Sensor inside the
Grill and turns on/off the Auger Motor and sets the Fire-pot
Fan speed. It can take some time for temperatures to
stabilise at the desired setting. Avoid frequently adjusting
the temperature or opening the lid.
The Grill internal temperature and two food temperature
probes can also be monitored on the display.
Controller Dial Settings
•
Shut Down Cycle: Safe shutdown after operation.
•
Smoke: Low temperature operation with maximum
amount of smoke. Smoke will appear in cycles.
•
82 ~ 190 C: Target temperature settings
o
•
High: 232 C maximum operating temperature
o
PROBE TEMP Button
•
Default display is the current Grill Temperature
•
Press the PROBE TEMP button to cycle through:
Grill Temperature ➤ PROBE 1 ➤ PROBE 2

7. Error Codes

Error codes will be displayed on the controller screen. All operation will cease when
there is an Error, so the problem must be solved before the grill can operate normally.
Check the Troubleshooting section for more detailed information as well.
Er1 = Temperature Sensor Failure
•
Check to ensure the Temperature Sensor cable plug is properly connected.
•
Check sensor cable connection on the controller board blue terminal block.
Er2 = Controller System Error
•
Reset the controller by following these steps:
•
Switch the Grill OFF and turn to Shut Down Cycle position
•
Switch Grill back ON and then turn to SMOKE to start normal operation
•
Error will display if Dial is already turned to a temperature when switching on.
LEr = Low Temperature Error. Grill internal temperature below 65
•
Grill may have run out of pellets or the Ignition Rod is not operating.
HEr = High Temperature Error. Grill internal temperature above 287
•
Turn to Shut Down Cycle position and switch the Grill OFF
•
Open the Grill Lid then switch the Grill back ON and turn to SMOKE position
•
Wait until the controller display has dropped below 90
and turn to the desired temperature.
•
High temperature error can also occur in hot weather when the grill in the direct
sun. Open the Grill Lid and move it into the shade to reduce the temperature.
C, then close the Grill Lid
o
8
C for 20min
o
C
o