Numark NS6 Service Manual

FUNCTION
1. POWER IN – Use the included power cable to connect NS6 to a power outlet. While the power is switched off, plug the
cable into NS6 first, then plug the cable into a power outlet.
2. POWER SWITCH – Turns NS6 on and off. Turn on NS6 after all input devices have been connected and before you
turn on amplifiers. Turn off amplifiers before you turn off NS6.
3. USB – This USB connection sends and receives audio and control information from a connected computer.
4. MASTER OUTPUT (XLR) – Connect this low-impedance XLR output to a PA system or powered monitors. The level
5. MASTER OUTPUT (RCA) – Use standard RCA cables to connect this output to a speaker or amplifier system. The
6. BOOTH/ZONE OUTPUT (RCA) – Use standard RCA cables to connect this output to a booth monitoring system. The
7. LINE INPUTS (RCA) – Connect line-level devices, such as CD players, samplers or audio interfaces, to these inputs.
8. MIC INPUT (1/4") – Connect a 1/4" microphone to this input. Microphone controls are located on the top panel.
9. LINE | PHONO INPUTS (RCA) – Connect your audio sources to these inputs. These inputs can accept both line and
10. LINE | MIC SWITCH – Flip this switch to the appropriate position, depending on the device connected to the LINE |
11. LINE | PHONO SWITCH – Flip this switch to the appropriate position, depending on the device connected to the
12. GROUNDING TERMINAL – If using phono-level turntables with a grounding wire, connect the grounding wire to
13. HEADPHONES – Connect your 1/4" or 1/8" headphones to this output for cueing and mix monitoring.
14. HEADPHONE VOLUME – Adjusts the volume level of the headphone output.
SERVICE MANUAL
SPECIFICATION
of this output is controlled with the MASTER knob on the top panel.
level of this output is controlled by the MASTER knob on the top panel.
level of this output is controlled by the BOOTH/ZONE knob on the top panel.
phono-level signals.
PHONO INPUTS. If you are using a microphone, set this switch to "MIC." If using a line-level
device, such as a CD player or sampler, set this switch to "LINE."
LINE | PHONO INPUTS. If you are using phono-level turntables, set this switch to
"PHONO" to provide the additionalamplification needed for phono-level signals. If using a
line-level device, such as a CD player or sampler, set this switch to "LINE."
these terminals. If you experience a low "hum" or "buzz", this could mean that your
turntables are not grounded.
MODEL:NS6