MDR-RF920R/RF960R
Specifications ............................................................................ 1
1.
................................................................... 2
2.
2-4. SW Board ................................................................ 5
3.
5
Turn up the volume to a moderate
level with the VOL control.
A MDR-RF960R
Press the TUNE button briefly for
automatic tuning of the headphones.
If you do not receive a clear audio
signal, press it again.
VOL control
B MDR-RF920R
Tune the headphones into the frequency
of the transmitter with the TUNE
control until you can hear the audio
signal loud and clear.
VOL control
Follow steps 3 and 5 above until the
receiving performance becomes better.
2
TABLE OF CONTENTS
4.
.......................... 7
5.
6.
SECTION 1
GENERAL
TUNE
button
TUNE
control
................................................. 17
This section is extracted
from instruction manual.
The headphones automatically turn
off when the y are taken off
- Auto power on/off function
Do not pull up the self-adjusting band when not
in use, as this will consume the battery power.
Flexible Circuit Board Repairing
•
Keep the temperature of the soldering iron around 270°C
during repairing.
•
Do not touch the soldering iron on the same conductor of
the circuit board (within 3 times).
•
Be careful not to apply force on the conductor when
soldering
.................................. 18