Portek CHARGER Operator's Handbook Manual page 8

8
Operation
IF THE LOG IS SPLIT AND THE RAM IS RETURNED TO THE START POSITION
Remove split pieces carefully and repeat operation for next log
IF LOG IS SPLIT BUT RAM DOES NOT RETURN
Clean and clear the surface below the ram from debris
IF LOG IS TOO KNOTTY AND DOES
A second or third attempt can be made but ensure the ram returns each time. Ensure the
motor and fl ywheel are up to speed before repeating the splitting process. (the motor
may stall and the thermal cut out will activate to stop the motor - the reset switch must be
pressed and wait for the power to be reset see page 5)
IF LOG IS STUCK ON THE SPLITTING WEDGE
Firstly return the handles to their starting position
first handle 2, then handle 1, to retract the ram.
Next, to free the log, give it a sharp knock with a
hammer away from the splitting wedge. If the ram
will not return first, then the log can be knocked
free before retracting the ram
Only when both handles are put in the complete
home position, 1 all the way forward, and 2 all
Tests have shown that most wood in the UK can be split satisfactorily, but some hardwoods such as
Apple can only typically be split in small sections.
With regular use you will get to know the limitations of the machine, it is essential to work
within them for a trouble free service.
Repeated motor stalling when trying to split very knotty wood will cause
the trip switch to operate, protecting the motor from damage. After a
short period, usually less than a minute, the trip can be reset by pressing
the push button. The unit can then be restarted as shown on page 5.
If a log is diffi cult to split and requires a few attempts ensure the motor
and fl ywheel are up to speed before repeating the splitting process.
NOT SPLIT
the way back, will the ram return.
DISCONNECT POWER SUPPLY BEFORE ATTEMPTING TO
REMOVE STUCK LOGS OR ANY ISSUES WITH RAM
POSITION AFTER ENCOUNTERING PROBLEMS
FIRST TIME
1
2