Num'axes PIE1037 User Manual page 24

Other
Settings
Language
Date/Time
Date format
Time stamp
Battery Type
Frequency
Cycle recording
Password
Reset
Update
Product information
10. Setting up the camera

Mount the camera facing north or south, not east or west as the rising and setting of the sun could produce false triggers and
overexposed images.

If you're covering a trail, face the camera down or up the trail.

Clear out any brush or weeds in front of the camera. These can cause false triggers due to temperature and motions disturbances in
front of the camera (especially in windy days).

Check the power level of the batteries.

Make sure the memory card is properly inserted and have sufficient available space.

Verify time and date are correct.

Make sure to turn the camera ON (switch in the ON position).
PIE1037 - Indice A – Juin 2019
Programmable options (default settings in bold characters)
English / Français / Español / Deutsch / Italiano
Auto / Manual
-
Auto
Time Zone
HH:MM
UTC +/- 00:00
The camera will synchronise the date/time after you enter your time zone information.
-
Manual
Date
20/03/2019
Manually set date/time.
NOTE: Please adjust the camera date and time to ensure some functions work as expected (stamp on
photos, daily report for example).
EU / US
EU (Europe): DD/MM/YY
US (United-States): MM/DD/YY
ON / OFF
Select "ON" if you want the date and time of the image capture imprinted on every photo. The current
temperature, moon phase and user set camera ID will also be imprinted on the still photos.
Alkaline / Ni-MH (nickel-metal hydride)
The device will perform better if you select the type of the batteries used in the camera.
You can purchase Ni-MH and alkaline batteries at any time on www.numaxes.com.
50Hz / 60Hz
An improper setting may cause the camera screen to flicker.
OFF / ON
When the SD card will be full, the camera will continue to record photos/videos by deleting the oldest
photos/video.
Select "OFF" then press "OK" to deactivate the cycle recording function.
OFF / ON
Select "ON" then press "OK" to enable password protection for your camera (6 digits/alphabets long
password).
No / Yes
Select "Yes" to reset the camera back to the factory default settings.
Insert the SD card with the update firmware inside, then enter this menu to update the camera
firmware by confirming "Yes" in the options.
This parameter shows the following information:
Ver (firmware version in camera) / IMEI / MCU / MOD
Time
15:55:00
24/28