DeWalt 399080-02 Instruction Manual page 20

399080-02 rev 11/15/02 10:13 AM
Repairs
To assure product SAFETY and RELIABILITY, repairs, mainte-
nance and adjustment should be performed by authorized service
centers or other qualified service personnel. Always use identical
replacement parts.
Motor Brushes
When brushes become worn, the tool will automatically stop, pre-
venting damage to the motor. Brush replacement should be per-
formed by D WALT authorized service centers or other qualified
E
service personnel. Qualified service personnel should follow the
procedures below when replacing motor brushes.
Turn off and unplug tool before making any adjustments or
removing or installing accessories. Before reconnecting the
tool, depress and release the trigger switch to ensure that the
tool is off.
1. Remove the brush doors located on the sides of motor housing.
2. To remove the brush, hold the female terminal, which is attached
to the brush lead wire, and disconnect the female terminal from
the male terminal.
3. Pull the brush straight up out of the brush holder.
4. Replace brushes, in pairs, with original D
able from D WALT authorized service centers.
E
5. Ensure that the brushes slide freely in brush box.
6. Reconnect the brush lead wire to brush box terminal.
7. Re-install the brush doors before using the tool. Torque screws to
10 in-lbs, maximum. Overtightening may cause screws to strip.
Page 16
WALT brushes avail-
E
Purchasing Accessories
Recommended accessories for use with your tool are available at
extra cost from you local dealer or authorized service center. If you
need assistance in locating any accessory for your tool, contact:
D WALT Industrial Tool Co., 701 East Joppa Road, Baltimore, MD
E
21286.
CAUTION: The use of any other accessory not recommended for
use with this tool could be hazardous.
Full Warranty
D WALT heavy duty industrial tools are warranted for one year
E
from date of purchase. We will repair, without charge, any defects
due to faulty materials or workmanship. For warranty repair infor-
mation, call 1-800-4-D WALT. This warranty does not apply to
E
accessories or damage caused where repairs have been made or
attempted by others. This warranty gives you specific legal rights
and you may have other rights which vary in certain states or
provinces.
In addition to the warranty, D
E
30 DAY NO RISK SATISFACTION GUARANTEE
If you are not completely satisfied with the performance of your
D WALT heavy duty industrial tool, simply return it to the participat-
E
ing seller within 30 days for a full refund. Please return the complete
unit, transportation prepaid. Proof of purchase may be required.
FREE WARNING LABEL REPLACEMENT: If your warning labels
become illegible or are missing, call 1-800-4-D
replacement. To request replacement labels, you will need to know
the rated rpm of your tool. The rpm of your tool is stamped into the
tool housing.
16
WALT tools are covered by our:
WALT for a free
E