Troubleshooting Guide - Victrola VTA-754B Manual

Symptom
Unit will not power on.
•
No sound output from
•
speakers.
Noise/Distortion in
•
sound output.
Unit fails to respond.
•
The tape does not play.
•
Cannot listen to any
•
station, or signal
appears weak.
The sound is distorted.
•
CD stops immediately
•
after starting, or unit
pauses or stops during
play.
No sound.
•
CD playback is noisy,
•
or playback stops or
skips.
CD tray will not open.
•
Buttons are not
•
functioning correctly.
Decline in turntable
•
audio performance.
The USB drive does
•
not play.

Troubleshooting Guide

Possible Cause
Unit is unplugged.
•
The volume level is set too low.
•
The input selector does not
•
match the playback source.
The unit is too close to a TV set
•
or another interfering device.
It might result from external
•
factors such as ESD
(Electro-static discharge).
The cassette tape is not inserted
•
properly.
The tape has reached the end.
•
The station is not tuned-in
•
properly.
A TV set is being used nearby
•
and is interfering with the radio
reception.
The antenna is not oriented
•
properly.
The CD is inserted upside down.
•
The CD is dusty or dirty or there
•
is condensation on the CD.
The CD player is paused.
•
The CD is scratched, damaged
•
or warped.
The disc is very dirty.
•
USB/BT/PHONO/AUX/FM/TAPE
•
mode is selected.
The unit is processing
•
information ("--- Busy" is
displayed).
The unit needs to be restarted.
•
The turntable stylus is worn out.
•
The USB drive is not inserted
•
properly.
The USB drive has no MP3 file.
•
17
Solution
Connect the unit to the
•
AC power supply.
Adjust the volume.
•
Select the correct
•
input source.
Turn off the TV or
•
other appliance, and
relocate the unit.
Disconnect the power
•
cord and external
audio device. Re-plug
the power cord after
one minute.
Insert the cassette
•
tape correctly.
Flip the cassette.
•
Properly tune-in the
•
desired station.
Turn-off the interfering
•
TV set.
Re-orient the antenna
•
until reception
improves.
Insert the CD with the
•
printed side right-side
up.
Carefully clean and
•
dry the CD.
Press the
•
PLAY/PAUSE button.
Replace CD with an
•
undamaged one.
Carefully clean the
•
CD.
Select CD mode.
•
Wait until the unit
•
finishes processing.
Turn the unit off, then
•
on again.
Replace the stylus.
•
Insert the USB drive
•
correctly.