Swisher LS934, LS622, LS826, LS10534D Owner's Manual
  1. Manuals
  2. Brands
  3. Swisher Manuals
  4. Log Splitter
  5. LS10534D
  6. Owner's manual
Swisher LS934, LS622, LS826, LS10534D Owner's Manual

Swisher LS934, LS622, LS826, LS10534D Owner's Manual

Swisher log splitter owner's manual
Hide thumbs Also See for LS934, LS622, LS826, LS10534D:

Advertisement

Table of Contents

swisherinc.com
OWNER'S
MANUAL
MODEL NO.
LS622
LS826
LS934
LS10534D
IMPORTANT
Read and follow all Safety
Precautions and Instructions
before operating this
equipment.
Rev.07.04.2001
1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093
Manufacturing quality lawn care equipment since 1945
LOG
SPLITTER
Safety
Assembly
Operation
Service and Adjustment
Repair Parts
FAX 660-747-8650
PHONE 660-747-8183
Made In The
USA

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the LS934, LS622, LS826, LS10534D and is the answer not in the manual?

Questions and answers

Related Manuals for Swisher LS934, LS622, LS826, LS10534D

Summary of Contents for Swisher LS934, LS622, LS826, LS10534D

  • Page 1 swisherinc.com OWNER’S MANUAL MODEL NO. LS622 LS826 LS934 LS10534D IMPORTANT Read and follow all Safety Precautions and Instructions before operating this equipment. Rev.07.04.2001 1602 CORPORATE DRIVE, WARRENSBURG, MISSOURI 64093 Manufacturing quality lawn care equipment since 1945 SPLITTER Safety Assembly Operation Service and Adjustment Repair Parts PHONE 660-747-8183...

  • Page 2: Safety Decals

    OD16 – FUEL SHUT OFF DECAL OD12 – HYDRAULIC FILL PLUG DECAL SAFETY DECALS Replace decals immediately if damaged. OD07 – COLD WEATHER DECAL OD23 – TOW POSITION DECAL OD22 – POSITION LOCK DECAL OD08 – OPERATOR INSTRUCTION DECAL OD09 – DANGER/POSITION LOCK DECAL...

  • Page 3: Parts List

    LS622, LS826, LS934 MODELS NOT ALL PARTS ARE ON ALL MODELS FENDERS ONLY ON LS934 MODEL ASSEMBLY DETAIL SEE DETAIL SEE DETAIL...

  • Page 4: Service Parts

    Please have Model and Serial Numbers ready when ordering parts. Color cannot be guaranteed upon service parts. ITEM NUMBER 1/2 X 3 1/2 HITCH PIN W/ HAIR PIN HYDRAULIC PUMP - LS622 MODEL HYDRAULIC PUMP - LS826 & LS934 MODELS FENDER BRACKET - RIGHT SIDE - LS934 ONLY FENDER BRACKET - LEFT SIDE - LS934 ONLY SERVICE PARTS...
  • Page 5 Pleas have Model and Serial Numbers ready when ordering parts. Color cannot be guaranteed upon service parts. ITEM NUMBER #14 x 3/4 SELF-TAPPING SCREW TOWING TONGUE - LS934 & LS10534D SERVICE PARTS DESCRIPTION MOTOR BASE / AXLE TIRE / WHEEL COTTER PIN WHEEL DUST COVER CASTLE NUT...
  • Page 6 See Detail See Detail ASSEMBLY DETAIL MODEL LS10534D NOT ALL PARTS ARE ON ALL MODELS...
  • Page 7 Please have Model and Serial Numbers ready when ordering parts. Color cannot be guaranteed upon service parts. ITEM NUMBER #14X 3/4 SELF TAPPING SCREW SERVICE PARTS DESCRIPTION 3/8-16 X 3 1/2 GR5 BOLT 3/8-16 X 3 GR5 BOLT 1/2-13 X 3 1/2 GR5 BOLT 1/2-13 X 1 1/4 GR5 BOLT 1/2-13 X 1 1/4 GR5 BOLT 3/8-16 X 1 GR5 BOLT...
  • Page 8 Please have Model and Serial Numbers ready when ordering parts. Color cannot be guaranteed upon service parts. ITEM NUMBER MOTOR BASE SUPPORT ARM NOT SHOWN NOT SHOWN NOT SHOWN SERVICE PARTS DESCRIPTION HYDRAULIC ELBOW PUMP PULLEY MOTOR BASE BELT 32.5 IDLER ARM IDLER PULLEY CLUTCH LEVER...
  • Page 9 ITEM NUMBER STATIONARY LINE ASSEMBLY RAM CYLINDER - LS622 MODEL RAM CYLINDER - LS826 MODEL RAM CYLINDER - LS934 & LS10534 MODELS 1/2-13 X 2 1/2 GR5 CARRIAGE BOLT BEAM WELDMENT - DELUXE MODELS BEAM DETAIL NOT ALL PARTS ARE ON ALL MODELS DESCRIPTION CLIP PIN STEEL PIN...

  • Page 10: Engine Detail

    ENGINE DETAIL LS826, LS934, LS10534D MODELS ITEM # THROTTLE & CABLE(NOT SHOWN) GOLDEN LOCK WASHER GOLDEN KEY SWITCH NUT EXISTING ENGINE HARDWARE 5/16-18 X 1 1/4 GR5 BOLT 5/16-18 2-WAY LOCK NUT 7/16-20 X 1 GR5 BOLT W/ NYLOCK NOTSHOWN NOTSHOWN THROTTLE PLATE/ SCREWS DESCRIPTION...
  • Page 11 Log Splitter V-Belt Replacement • Caution! : The Idler System is spring loaded. When replacing belt, be sure to lock lever to avoid accidental release. Remove the (6) self-tapping screws that hold the belt cover on the • bottom of the unit and remove the cover to allow access to the belt. Pull clutch lever out to remove load from belt.
  • Page 12 Log Splitter V-Belt Replacement (Continued) Check pulleys for alignment ∀ • Check Idler for freedom of rotation ∀ • Check to be sure Clutch Lever is straight and moves freely. See Fig.3 ∀ • Fig.3 Install new belt • Replace pulley cover and (6) screws •...

  • Page 13: Assembly Instructions

    Optional Extended Table For Log Splitter Kit No 7490 This table is designed to fit both the Standard and the Deluxe Swisher Log Splitter. The Standard attachment slips over the beam pivot tube and attaches with the hitch pin through the vertical beam lock hole.
  • Page 14 Log Stripper and Table Detail Log Stripper Installation Instructions Turn off engine and disconnect spark plug wire. Place wire so it cannot make a connection to the engine. Check to make sure parts and hardware match Bill of Materials (Parts Listing). Place the Stripper Bracket (#4) around cylinder as shown.
  • Page 15 LS622 Splitting 22 Tons Force 6 Hp Briggs and Engine Stratton Quantum Splitting Horizontial and Positions Vertical Cylinder 4" X 24" Size 2 Stage with Heavy Pump Duty Bearings Pump 11 Gallons Per Specs Minute Valve Auto Return Belt Drive 1:1 Ratio Drive with Clutch for System...

  • Page 16: Log Splitter

    All Log Splitter parts listed herein may be ordered directly from Swisher Mower & Machine Co. Inc., your nearest Swisher dealer, or from our website. All engine parts may be ordered from the nearest dealer of the engine supplied with your mower without notice.

Table of Contents

Save PDF