Sony DFP-R3000 Installation Manual page 28

Procedure
Step 1. Installing the Adapter (A) to the Projector
1. Remove REEL ARM or platter guide roller of supply
reel side of the projector.
2. Attach the adapter (H) to the projector using the two
hexagon cap screws (3/8-16) 1.
3. Attach the adapter (A) tentatively to the adapter (H)
using the two hexagon cap screws (3/8-16) 2, two
wabe washers (10) and washers (W10).
n
Fixing hole of adapter (A) varies depending on the
projector to be used. (See the figure below.)
4. Attach the path adjustment tool tentatively to the
adapter (A) with the two hexagon cap screws (M4 x
12) 3, two washers (W4) and two spring washers
(SW4) as shown in the figure.
5. Put a film on the path adjustment tool (roller) from the
projector, and adjust the attaching position of the path
adjustment tool so that the film is smoothly fed onto
the projector.
6. After the adjustment has been completed, tighten the
two hexagon cap screws (M4 x 12) 3.
7. Put a film on the path adjustment tool (roller) from the
projector, and adjust the attaching position of the
adapter (A) so that the film is smoothly fed onto the
projector.
Especially adjust so that the tension on both edges of
the film is even.
8. After the adjustment has been completed, tighten the
two hexagon cap screws (3/8-16) 2.
9. Remove the film from the path adjustment tool.
10. Remove the path adjustment tool from the adapter (A).
1-24 (E)
Path adjustment tool
2
Hexagon cap screw
(3/8-16)
Wave washer (10)
Washer (W10)
Washer (W4)
Spring washer
(SW4)
3 Hexagon cap screw
(M4 x 12)
1
Adapter (H)
Path adjustment tool
Film
3
Hexagon cap screw
(M4 x 12)
2
Spring washer
(SW4)
Washer (W4)
Adapter (A)
1 Hexagon cap screw
(3/8-16)
Projector
P35
Adapter (A)
Projector
P35
DFP-R3000