Safety Precautions; Compliance With Fcc Regulation - Halo Pocket Power 6000 Operating Instructions Manual

SAFETY PRECAUTIONS

• Read all instructions before using the product.
• Keep your power bank dry and away from moisture and corrosive
materials. The power bank should not be used near water or wet areas
such as bathtubs, showers, bathrooms, sinks, swimming pools or
basements.
• Do not clean your power bank with harsh chemicals, soaps or
detergents. Just wipe the case with a soft cloth.
• Keep your power bank away from heat sources, including open ames,
radiators, stoves, ovens, and any other devices that product heat.
• Do not puncture, crush or subject to mechanical shock.
• Do not attempt to disassemble.
• Make sure the power bank's charging ports do not become
contaminated with lint or other debris. Use a canned-air type of
product periodically to ensure that the port openings are clear.
• Recharge your power bank once every three months when not in use.

COMPLIANCE WITH FCC REGULATION

This device complies with part 15 of the FCC Rules and RSS-Gen of IC
Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment o and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit di erent from that to
WWW.BESTHALO.COM | 4