Firmware Update - Gigaset CL390HX Manual

Phone settings
Resetting the base
(depending on the base)
A reset disables mode No Radiation, resets individual settings and deletes all lists.
The system PIN is reset to the original code 0000.
The time and date are not affected. The answer machine (if available) is not ready until after
about 15 seconds after the base is reset.
Resetting the base from the menu
The handsets remain registered. The system PIN is not reset.
¤
Menu Settings
Resetting the base using a key on the base
All handsets are de-registered. The system PIN is set back to the original code 0000.
¤
Remove the power cable from the base
base At the same time, reconnect the power cable to the base
for at least another 5 seconds

Firmware update

(depending on the base)
The handset supports firmware updating via the DECT radio link to the base/router (SUOTA =
Software Update Over The Air).
The base/router to which the handset is registered must also support this function and
be connected to the Internet
www.gigaset.com/compatibility
¤
Menu Settings
Showing the current firmware version:
Updating firmware:
The update process may take up to 30 minutes. During this time, only restricted
handset use is available.
Automatically check whether there is new firmware:
¤
Menu Settings
( = enabled)
If new firmware is available for the handset, a message to this effect is displayed.
¤
Start the firmware update with OK.
34
OK System
Keep pressed the Registration/paging key on the
OK Firmware Update
¤
Current Version
¤
Update
is started
OK Firmware Update
Availability and operation of the functions
may differ on your telephone.
OK Reset Base
OK
OK
OK . . . If there is new firmware, the update
Automatic Check
OK . . . Reset?
Keep the key pressed
OK
OK