Troubleshooting - Vacmaster UC0101 Use & Care Manual

Should you have any problem(s) with your vacuum cleaner, review the table
below for solutions to minor performance issues.
WARNING
Disconnect electrical supply before performing maintenance to the vacuum
cleaner. Failure to do so could result in electrical shock or personal injury.
PROBLEM
Vacuum will not
power on.
The job of dirt
pick-up is poor
or suction power
is weak.

TROUBLESHOOTING

POSSIBLE CAUSE
The plug is not plugged to the
wall outlet.
The On/Off button is not pressed
to start the vacuum cleaner.
The vacuum body is overheated.
The motor is damaged.
Dust cup is full or clogged.
The primary filter or the pre-filter
needs cleaning.
The brush roll is worn.
The belt is worn or broken.
The hose is worn.
The primary filter needs to be
replaced.
There is a clog in the hose or
connection hose of the vacuum
cleaner.
Be sure power cord plug is fully plugged
into outlet.
Press the on/off switch to start the
vacuum cleaner.
Unplug the power cord and let the
vacuum cool down for 50 minutes.
Call (866) 384-8432 for assistance.
Empty the dust cup.
Follow filter cleaning instructions on
page 19 or 20.
Call (866) 384-8432 for assistance.
Replace the belt. Purchase online at
www.vacmaster.com or call (866) 384-
8432.
Replace the hose. Purchase online at
www.vacmaster.com or call (866) 384-
8432.
Purchase online at www.vacmaster.com
or call (866) 384-8432.
Check and remove all clogs. Follow
instructions on page 26.
-27-
SOLUTION