Wirquin Macdee Kayla Quick Start Manual

FLUSHING
KAYLA Flushing Valve
Adjustable
overflow
Branded
top
Adjustable flush
volumes (full &
part flush)
Seal
Coupling Nut
SLIDE
To adjust the full flush, move the slide down for more and up for
less. Part flush move the float up for less and down for more.
Always keep the part flush float 1 notch above the full flush setting.
DO NOT GO BELOW SETTING 8
Code: PM000PPB
Issue No. 03
Date: 19/11/15
Grey top
1.5m air hoses
Colour coded float
adjuster (grey)
Removable
top
Grey seal
2" outlet
2" or 1.5" Outlet
1.5" Flushpipe
Place the coupling nut, followed by
the seal, on the flushpipe, secure
coupling nut hand tight, tighten
further if necessary, fit finned
flushpipe connector on to flushpipe,
insert into W.C. pan.
Finned flushpipe connector
315mm
maximum
FLOAT
240mm
minimum
The overflow is adjustable from 240mm to 315mm in height. Clip
and lock the overflow 20mm above the waterline in the cistern.
Ensure the overflow is capable of discharging the incoming water.
2"
1 5"
Seal
Step Ring
Coupling Nut
1.5" and 2"
Outlet Valve
Insert threaded
section of the valve
into cistern, with base
seal on the inside,
secure with back-nut
hand tight, tighten
further 1/2 turn using
a spanner, check for
leaks, tighten further
if necessary.
2" Flushpipe
Place the coupling nut, followed by slip ring,
then the seal on the flushpipe, ensure the seal
has the bevelled edge pointing towards the
end of the flushpipe, insert the flushpipe up
to the stops in the valve base then secure
coupling nut hand tight, tighten further if
necessary, fit finned flushpipe connector onto
1.5" end of flushpipe, insert into W.C. pan.
Finned flushpipe connector
HOSE
CONNECTOR
Blue
Clear
Connect the hoses to the button, blue hose to the
end of the barrel nozzle, clear to the centre nozzle.
Make sure the hose connection is firmly on the
nozzle and in the correct order or the part flush
will not work.