Visonic TOWER-32AMPG2 Installation Instructions Manual page 3

1. On the indicated location, lift the screw cover upward using your thumb.
2. Release the screw and open the cover in the direction shown by the arrow.
3. Insert a screwdriver into the slot and then push inward to separate the base from the cover.
4. Set the desired detector range.
5. Insert battery while observing polarity.
A. Mounting height
B. Coverage range
C. Break-away base segment (shaded) for back tamper
D. Enroll button (use a screwdriver to press the recessed button)
E. Battery
F. Tamper switch
CAUTION!
THE BACK TAMPER SWITCH WILL NOT PROTECT THE UNIT UNLESS THE BREAK-AWAY BASE SEGMENT IS SECURED TO
THE WALL WITH AT LEAST ONE SCREW.
RISK OF EXPLOSION IF BATTERY IS REPLACED BY AN INCORRECT TYPE. DISPOSE OF USED BATTERY ACCORDING TO
MANUFACTURER'S INSTRUCTIONS.
Note: The Tower 32AM Series wireless PIR Motion detectors shall be installed and used within an environment that provides the
pollution degree max 2 and overvoltages category II, NON HAZARDOUS LOCATIONS, indoor only. The detector is designed to be
installed by service persons only.
2.3 Ceiling Mounting
Figure 4. Ceiling Mounting
2.4. Enrollment
Refer to the PowerMaster control panel's Installer Guide and follow the procedure under the "02:ZONES/DEVICES" option of the
Installer Menu. A general description of the procedure is provided in the following flow chart.
Step 1
Enter the Installer menu
and select
"02:ZONES/DEVICES"
02:ZONES/DEVICES
Step 6
Enter PARTITIONS. Assign partitions to the
detector by pressing the
See Note 2
Z14:PARTITIONS
means scroll and select
D-303780 TOWER-32AM PG2, TOWER-32AM K9-90 PG2 Installation Instructions
Step 2
Select "ADD NEW
DEVICE"
See Note 1
ADD NEW DEVICES
MODIFY DEVICES
Step 7
, and
buttons on the panel
F02:P1 P2 P3
Following are general instructions for ceiling
mounting of the detector. For more detailed
instructions, please refer to the BR-3 Installation
Instructions.
Note: The back tamper is not active when
mounting the detector on the ceiling.
1. Remove the front cover as shown in Figure
2. Punch out the selected knockout in the bracket
3. Assemble the bracket as shown in Figure 4.
4. Rotate the bracket to the desired position but
5. Press the bracket base against the mounting
6. Attach the bracket to the mounting surface using
7. Tilt the detector down or swivel it so that it
A. Rear side of detector
Step 3
Enroll the device or enter the
device ID
ENROLL NOW or
ENTR ID:XXX-XXXX
Step 8
Select the "DEV SETTINGS"
option and refer to the
section below to configure
the detector parameters.
F02: DEV SETTINGS
3, points 2 and 3.
(see Figure 3, point 4).
do not yet tighten the screw fully.
surface and mark the points for drilling. Drill out
the holes and insert plastic anchors.
the two screws supplied with the detector.
faces the desired direction.
Step 4
Select the desired detector Configure Location,
number for the new Zone Type & Chime
detector Parameters
Z14:Motion Sens
Z14.LOCATION
ID No. 123-XXXX
Z14.ZONE TYPE
Z14.SET CHIME
Step 5
3