Summary of Contents for Mountain Buggy Haven with safeguard
Page 1
READ FOR YOUR CHILD'S SAFETY haven ™ THESE INSTRUCTIONS with safeguard ™ CAREFULLY BEFORE USE Group 1, 2, 3 Suitable for Children 9 – 36kg KEEP FOR FUTURE REFERENCE...
Page 2
The haven with safeguard complies with requirements ™ ™ applicable in market of sale For rights & remedies, refer www.mountainbuggy.com/warranty Please register your product purchase through our online warranty registration by visiting: www.mountainbuggy.com/register mountainbuggy.com...
Page 3
Congratulations on choosing your new car seat! Product Care Safety Warnings Features Instructions...
Product care GENERAL INSTRUCTIONS CLEANING & CARING Check your car seat for cuts & bruises. If your product Group 1, 2, 3 is damaged in any way, or you’re not sure how to use Suitable for children 9 to 36kg. it, please consult our web support from where you can access a local customer care team.
Page 5
Product care Cleaning the seat: IMPORTANT • Sponge clean only. Use hand soap and warm water. Please read thoroughly before commencing • DO NOT use solvents, detergents or washing up installation as an incorrect installation could be liquids as these may weaken the seat. dangerous.
Page 6
Safety Warnings WARNINGS • Do not use a second-hand car seat or car seat whose history you do not know. • PLEASE READ ALL INSTRUCTIONS IN The rigid items and plastic parts of a child THIS MANUAL AND IN THE VEHICLE restraint must be so located and installed OWNER’S MANUAL RELATED TO CAR that they are not liable, during everyday...
Page 7
Safety Warnings this car seat except as instructed in this such as luggage or books, in your car as manual. they may cause injuries in the event of an • Do not use belt routing methods not shown accident. in these instructions. •...
Page 8
Safety Warnings be twisted; ensuring that any lap strap is worn low down, so that the pelvis is firmly engaged. • Don’t let the adult safety-belt buckle interfere with the main load bearing contact points on the car seat. Please contact the car seat manufacturer if in doubt about this point.
Page 10
Safety Warnings Do not use on a passenger seat with a front airbag. On outer rear seat On centre rear seat with 3-point belt On a rearward-facing seat On seats facing sidewards On rear seat with lapbelt only Front seat with airbag off...
Safety Warnings CHECKLIST BEFORE USE Haven with Safeguard (9–18kg child) Haven without Safeguard (15–36kg child) Inspect Inspect • Child restraint free of damage • Child restraint free of damage Verify Child within Size Range Verify Child within Size Range • Weight: between 9kg and 18kg •...
Page 12
Features Features Headrest Shoulder Belt Guide Protection Flank Belt Guide FIX Connector FIX Adjustment Button Seat Safeguard ISOFIT guider sleeve...
Page 13
Features Features Backrest Adjust Button Belt Guide Backrest Cover Backrest Angle Supporting stop Belt Guide Base Adjustor...
Page 14
Instructions ADJUSTING BACKREST AND HEADREST Backrest Angle Adjustment There are 2 positions for the Backrest. 1. Push outwards the Adjustment Stops on the two sides and the backrest can be adjusted into Upright Position. 2. Push inwards the Adjustment Stops on the two sides and the backrest can be adjusted into Recline Position.
Page 15
Instructions Base Supporting Angle Adjustment While used as group 1, the car seat Base Adjustor can be pulled out to adjust the base angle. WARNING: The car seat Base Adjustor is only used for group 1 (from 9–18kg). Please do not pull out the Base Adjustor for group 2 and 3 (from 15–36kg).
Page 16
Instructions ISOFIT instruction Note: Please install the ISOFIT guider sleeve onto the ISOFIT anchorage (1) when connect the ISOFIT connector to the anchorages which is between the vehicle seat surface and the vehicle back. See diagrams:...
Page 17
Instructions Pinch the FIX Child Restraint with Safeguard (9-18kg Child) Adjustment Buttons on the two sides and WARNING: push out the legs. In order to use the restraint as group 1 (from 9 to 18 kg) it should be used along with the safeguard. The car seat MUST be used with a 3 point vehicle seat belt when used as a child restraint with safeguard.
Page 18
Instructions Put the baby into the car seat and insert the safeguard in the front. Meanwhile, pull the vehicle belt latch plate, route the vehicle shoulder and lap belt through the belt guides on the two sides of the safeguard and lock the vehicle belt latch plate into the belt buckle on the other side.
Page 19
Instructions Child Restraint without Safeguard (15-36kg Child) The child seat MUST be used with a 3 point vehicle seat belt when used as a booster. Safeguard will need to be removed. Put the car seat on the vehicle seat, align it with the ISOFIT interface in the vehicle seat and push forward.
Page 20
Instructions WARNING 1. Put the child seat on a forward-facing vehicle seat (5a). • Make sure the lap section of the vehicle 2. Have the child sit on the booster seat so their back belt rests as low as possible over the child's contacts the backrest from shoulders to bottom.
Instructions REMOVING THE COVER 1. Remove the headrest cover. (6a) 2. Remove the backrest cover. (6b) 3. Remove the cushion cover. (6c) REMOVING THE COVER The plastic shell of the seat is comprised of two layers (inner and outer) with a small gap between. Secure the cover by feeding it between the two layers as shown in the diagrams, beginning at the headrest and working down to the seat cushion.
Instructions CARE AND MAINTENANCE Periodically inspect your car seat for worn or damaged parts. If damaged parts are found, replace the child seat. COVER The fabric parts can be cleaned according to the instructions on the washing label.
Need help?
Do you have a question about the Haven with safeguard and is the answer not in the manual?
Questions and answers