Calibration Techniques; How To Ensure Your Spreader Is Properly Calibrated; Rod Type Adjustment - EarthWay 2600A-Plus Estate Assembly And Operating Instructions Manual

Broadcast spreader

Hide thumbs Also See for 2600A-Plus Estate:

User manual

Assembly instructions manual (10 pages)

Assembly and operating instructions (5 pages)

Table Of Contents

Table of Contents

Broadcast Setting Matrix

How to ensure your spreader is properly calibrated

Make sure the drop holes in the bottom of the hopper are fully open when the Rate Control handle is on #30. If not,

please adjust the control rod to allow for a full open hopper position at #30.

Rod Type Adjustment

Open the shut-off so that the drop holes are completely open as illustrated below.

Review the Control Lever position - if it is set so that the forward edge is at #30,

you are calibrated. If not, you need to adjust the control rod at the pivot bracket

shown in Fig 1.

If your shut-off is able to open fully as in step #1, but the Control Lever is not at

#30. Loosen #14 Nut, then slide the Control Rod (#12) in the Gauge & Linkage

Assembly (#8) so that it allows you to push the Control Lever to #30. Next tighten

#14 Nut. Recheck adjustment as outlined above.

If you have any questions regarding the operation or assembly of your spreader please call us at 800-294-0671 or

574-848-7491 Monday - Friday 9:00am - 4:00pm Eastern. Accessories and Repair Parts are also available at these

numbers.

Fig 1